The red Canare Starquad XLR-TRSM Cable Red 75ftis handcrafted with the super flexible Canare L-4E6S cable and superior Neutrik XLR and TRS Phone connectors. Use Starquad for reduced hum and EMI, and no handling noise. This cable is perfect for all microphone use and great for connecting balanced output of some audio processors, mixers, and low density patch bays to XLR inputs.

Special cross-linked PE insulation

Hand assembly with true silver solder

Pure performance Neutrik XLR and Neutrik Phone connectors

Related Questions and Answers

Q: 1. I'm sorry, I should have clarified my last question - I was asking if the stud/spigot that mounts to the base clamp is 5/8" in width? I'm planning on using a different clamp with a 5/8" receiver. (BH#SACSGC) Thank you.

A: The base stud/spigot is not specified.

Q: 2. Does this work well with video booths? Like not picking up a lot of the DJ music and crowd talking? I just want to make sure the video recorded you can hear the people talking and making the video.

A: that's kind of a tough question. I love my NTg2 mic, it works much better than I thought using a windscreen and as well as being directional to block out some noise. If you are in a noisy environment why not double up on this along with a lab mic for best results?

Q: 3. Can I leave the AA battery in or do I need to remove it when I'm done recording?

A: You can leave a AA battery inside of the RODE NTG2 Shotgun Microphone as long as you will be using the mic again within a few days. Otherwise, it is always best to remove the battery from an electronic device that will not be used for a while in order to prevent damage from problems caused by the battery leaking.

Q: 4. This cable work with red v raptor?

A: Yes. The following cable is a run/stop cable for the tilta nucleus system.

Q: 5. Will this work with Red Ranger?

A: No, the RED Ranger is not part of the DSMC2 lineup and does not have a 7-pin port.

Q: 6. does it goes to red dragon 6k?

A: This is for DSMC1, the Red Dragon 6K is DSMC2. This cable will not work. Instead you need BH #TIRS02RD which is for DSMC2. https://bhpho.to/2KLnMAN

Q: 7. This cable work with Red Komodo X? (Not the first Komodo).

A: The Tilta Nucleus-M RED DSMC2 Run/Stop Cable (27") is compatible with the RED Komodo X, so long as you use the Tilta Advanced I/O Module for RED V-RAPTOR (BH #TIESRT08IOM) as a means for the cable to interface with the cameras. See: https://bit.ly/3HMMTO3

Q: 8. Does this include the permanent desk mount shown in photo? (Or just clamp)

A: Yes. There are two mounts included with the BA-XE4. One is the C-clamp mount and the other is the permanent flange mount.

Q: 9. Does it goes to Red Dragon 6K?in overview was written 7-pin & Micro-B usb.

A: Depending on whether you have the DSMC1 or DSMC2 body, this is made for the DSMC1

Q: 10. Does it provide power to the Nucleus-M motor?

A: It does not. This is just a Run/Stop Cable.