The yellow, 100' Canare Star Quad 3-Pin XLR Male to 1/4 TRS Male Cable is handcrafted with superflexible Canare L-4E6S cable and features high-quality Neutrik XLR and TRS phone connectors. The Star Quad series has been engineered to dramatically reduce hum and electromagnetic interference (EMI) for outstanding signal transparency both in the studio and on stage. Designed to virtually eliminate handling noise, this cable is well-suited for connecting a balanced 1/4" TRS audio output, like those found on many mics and instruments, to a balanced XLR input on a mixer, PA speaker, or similar device.

Greatly Reduces Hum and EMI    Designed to Eliminate Handling Noise    21 AWG, Canare L-4E6S Cable    Neutrik Connectors

Special crosslinked PE insulation

Hand assembly with true silver solder

Pure performance Neutrik XLR and Neutrik Phone connectors

21 AWG cable with copper conductors

Great for extended cable runs over 25'

Related Questions and Answers

Q: 1. is it compatible with saramonic blink 500 pro?

A: Yes you can use the Saramonic SR-UM10-C35XLR with the Saramonic Blink 500 Pro receiver.

Q: 2. Is this also compatible with the H5 and H6?

A: At this time, the EXH-8 module is only compatible with the Zoom H8.

Q: 3. How long is the Locking 3.5mm TRS to XLR-Male cable?

A: The cable is 16" long, minus the connectors. End to end, connector to connector it is approximately 21.25".

Q: 4. Will it come with an AC adaptor for the power source required to run phantom power?

A: The power adapter for the EXH-8 would be a separate purchase.

Q: 5. Can I use this cable to connect my Sony UWP RX to the TA3 connection of the Mixpre-10 II?

A: No, you would instead use BH #CAMINLPUOX18 for connecting your Sony receiver into one of the XLR mic inputs on the Sound Devices MixPre-10 II.

Q: 6. Why does this module have a power input? Can it be used by itself as a separate recorder?

A: The DC5V USB-C power input on the Zoom EXH-6e Dual XLR-1/4" TRS Input Capsule for H6essential Portable Recorder would be used for powering condenser microphones with an XLR connector, because these types of mics require 48V phantom power.

Q: 7. Would this cable provide separate tracks out of the UwMic9, or will it be both channels mixed into both XLR’s?

A: Both channels would be mixed on both XLRs because all of the audio from both microphones is coming from a single output on the Saramonic RX9 receiver.

Q: 8. Is this adapter cable compatible with any XLR microphone?

A: No . It is compatible withe listed Saramonic products.

Q: 9. Which pins are the tip, ring, and sleeve wired to, respectively?

A: Unfortunately Saramonic has not made a wiring diagram for the SR-UM10-C35XLR available.

Q: 10. What is the length of this cable?

A: The cable is 17" long. From end to end of the 3.5mm connector to the XLR connectors is 21".