This 4 x 5.65" Tiffen Soft FX 2 IRND Filter 4x5.65" 3-Stopis an all-in-one filter combining the benefits of multiple filters. Tiffen has combined innovative IRND technology with the Soft/FX filters that retain overall image clarity while softening unwanted details. This filter combines IRND to allow selective aperture and IR control with the pleasing softness of Soft/FX to deliver a great overall effect.

Tiffen's ColorCore technology provides filmmakers with the necessary tools to create the world's greatest images.

0.9 Optical Density    ColorCore Technology

3 filters in one, reducing multiple surfaces and potential reflection from stacked filters

Tiny lenslets put fine image elements out of focus while leaving large details sharp

Lighter densities are very subtle, producing almost no flare

Higher densities are more noticeable but still provide a pleasing portrait

Eliminates the potential "too sharp" look of modern cameras and lenses

For digital cameras with CMOS & CCD sensors with heightened response to the Red channel

Absorbs pollution of the Far Red (visible) and Near Infrared wavelengths

IR absorbing component is proportionate to the ND value

Ideal for lightweight or clip-on matte boxes

Made from water white glass

IRND+SFX will not ripple or distort when panning

Related Questions and Answers

Q: 1. Is this rack mountable?

A: Yes, and it comes with the rack mouning hardware.

Q: 2. Is this mixer same size as yamaha mg16xu ?

A: Yes, the Yamaha MG20XU and MG16XU mixers are both the same size. The dimensions are 17.5 x 5.1 x 19.7" (444 x 130 x 500mm).

Q: 3. Without the aperture ring, can I use manual mode on the X-H1 and change the aperture with the back dial? Or can I only use auto aperture?

A: Auto exposure only.

Q: 4. Does it support IBIS for XT5?

A: Yes, the Fringer NF-FX II supports the Fuji XT5's IBIS.

Q: 5. Would this works nicely with a XH2s ? IBIS support and Phase AF ?

A: Yes, the Fringer NF-FX II Nikon F Lens to FUJIFILM X Camera Adapter will work with the FUJIFILM X-H2S Mirrorless Camera (B&H # FUXH2S), because of the high performance stacked sensor.

Q: 6. If I connect to a laptop via USB, is it possible to mix recorded channels separately with DAW software? E.G. Record a live band to laptop and then mix each input post recording. If so, which software would I need? Thanks

A: The USB interface is 2in/2out. You will be transmitting the main stereo mix to your computer via USB. Individual channels are not able to be routed to separate channels in a DAW via this mixer.

Q: 7. For the USB output, will the entire stereo mix of all inputs be sent over USB?The description says it provides two channels out - I presume these are the two L/R channels of the full mix?

A: On the MG16XU the signal from the STEREO L/R bus is output is output to the computer via the USB connection. This is sourced pre fader and not affected by the STEREO master fader.

Q: 8. This works with the autofocus motor for AF-D lenses?

A: The Fringer NF-FX II Nikon F Lens to FUJIFILM X Camera Adapter does not support autofocus with Nikon AF-D lenses.

Q: 9. is it HD and LCD rated so no glare or dulling bin out side sunlight? Can It be cut to fit? or do you have a porduct that can. P

A: The Sony Soft LCD Protector will not dull the LCD screens. However, depending on the angle of the light, you might get glare. It is made for 3.5" LCD screens and cannot be cut. The Sensei Cut-to-Fit Soft LCD Screen Protector (6 Pack) could be cut to size. Here is the link: https://bhpho.to/3ZRZeYN.

Q: 10. Is this a good Mixer for the Shure SM7B? I recently bought this mic and I understand it needs a lot of Pre amp gain, at least 60+db.

A: While this can used with the SM7B, it is highly recommended to purchase a signal booster to add additional gain to the mic before the mixer. An example would be the CloudLifter B&H # CLCL1.