The FSR DR-SOCK Pulling Sock is a handy cable pulling tool designed for use with the DR-PCB-HxxM HDMI Digital Ribbon Cable. It protects cables and connectors from being damaged by taking the stress off of the connection points while pulling.

Fast and simple cable installation

Protects terminated cables when pulling them through the conduit

Brightly colored pull sleeve tip for easy identification

Steel ring for quick & positive attachment of pull snake

Reusable for multiple jobs

Comes assembled and ready-to-use

Made of durable materials in the USA

Related Questions and Answers

Q: 1. I know this is a photo accessory, but am wondering if it can be used on a regular house lamp???

A: I would not recommend it. Most studio strobes (photography flashes) fire very bright, but very quickly with limited heat exchange in the burst. When the flash modeling lamp is on (which is similar to a household lamp, but smaller) the diffuser sock does cause the lamp to heat up much more than it would normally. Most manufacturers recommend keeping the modeling lamp on only temporarily when using a sock, so I wouldn't recommend using it with a standard lamp unless the lamp is significantly vented in another direction (and even then, I don't think anyone can be sure the sock itself won't discolor over time exposed to regular heat/light). There's a chance this could melt if it gets too close to the bulb. Hope that helps!

Q: 2. We have a few Smith Vector FL-3 Flourescent, continuous lights. They measure 16.5 outside diameter. Would these fit? Would you recommend these for this product?

A: Thats a good question, I believe I have an 18 inch, and it fits just right, it might but just a bit loose and should work. I hope this helps.

Q: 3. Do you have any sock type diffusers , like the 18 Diffuser Sock, for continuous 100w (equivalent) LED light source bulb? Thank you.

A: We would need to know which light fixture you are using to make a recommendation or to see if there are any accessories for your stated needs. You would have to e-mail your inquiry to stagelighting@a href= http://bhphotovideo.com target= _blank bhphotovideo.com/a with more information about the light fixture you own and which accessories you need for us to be able to assist you with your inquiry.

Q: 4. I have Xfinity cable box connected to a Sony H800x tv with eArc that is connected to a Sonos Arc. I am having lip synch problems and talked to Sony and Sonos however we were not able to fix it. Will this device correct the lip synch problem? Is the device powered?

A: We are not aware of this being able to correct sync issues.

Q: 5. Is it hdmi 2.1

A: Yes

Q: 6. Which size fits a Profoto OCF Magnum Reflector?

A: Please review the following item in order to accommodate the ocf unit Profoto OCF Magnum Reflector BH #PR100793 • MFR #100793 https://bhpho.to/3xrWpAy

Q: 7. Can this be used on the Elinchrome 8.25" standard reflector?

A: No, the Impact 7" Diffuser Sock does not fit onto the Elinchrome 8.25" standard reflector.

Q: 8. Can you use this on a continuous led light or is just made for strobe lights?

A: This sock can be used on LED and fluorescent continuous lights as well as strobes.

Q: 9. Will this sock work with a Studio Essentials White Beauty Dish (22 )?

A: It should since my beauty dish is 22. It has elastic around the edge so no special attachment needed.

Q: 10. Does it support 4K 120 Hz???

A: Yes the FSR DR-H2.1-10M has 48 Gbps bandwidth, supporting 8K at 60Hz or 4K at 120Hz.