The paintable white In-Ceiling Speaker with Tile Bridge and Backcan from OWI Inc. is a 70V system that features a 5.25” (13.34cm) dual cone and consumes a maximum of 4W of power. It is suitable for covered outdoor installation and features a paintable white aluminum grill.

70V Ceiling Speaker    5.25" (13.34cm) Dual Cone    Maximum 4W    For Covered Outdoor Installation    Paintable White Aluminum Grill    With Tile Bridge and Backcan

70V system

2-way dual cone

0.5 / 1 / 2 / 4W power

Works in covered outdoor installations

Aluminum grill

Related Questions and Answers

Q: 1. Does sidus bridge works with 120d version 1?

A: Yes the Sidus Link Bridge can work with the original C120D.

Q: 2. What is the latency for internet streaming to the bridge?

A: The latency for internet streaming to the bridge Blackmagic Design ATEM Streaming Bridge for ATEM Mini Pro Streaming Switchers, can depend on the internet setup you are using. But an estimated to be around 1 second.

Q: 3. Will this work with the Studio Pro HD?

A: No, that will not work.

Q: 4. Can I take the ethernet out of the Atem Mini Pro into a network switch and send the video output to any or all of the network switch ports to output with ethernet to sdi/hdmi converters?

A: Yes, that should work. In the ATEM Control Software you will see the Stream Bridge come up as one of the options to stream to.

Q: 5. Does the HDMI/SDI output use the compressed H.264 feed from the ATEM encoder? Or does it output the higher quality feed from your camera/source?

A: The Streaming Bridge gets it's input from the streaming output of the ATEM Mini Pro which will be H.264 encoded. The image will be quite good but it is compressed.

Q: 6. Is this the cartridge/casing I need to put an SSD card into so it will fit into the NSB-25?

A: Yes this is the correct item for using a SSD with the NSB-25.

Q: 7. Does this support a Manfrotto Nitrotech N12 head?

A: Yes, this will work with the Manfrotto N12 Head.

Q: 8. If this is used to connect over the internet, would the quality be sufficient to remotely pull a chroma key from the feed?

A: Pulling a chroma Key from a compressed image would be difficult, an uncompressed signal is recommended for pulling any sort of key

Q: 9. For a client that has a Mini Pro, and a Mini Pro Extreme - am I correct in assuming we can take the ethernet out of the Extreme to the Bridge; an HDMI out to the Mini Pro so that we can stream? Then, do lobby monitors get fed only through SDI, or can the network also pick up the feed and send it to specific monitors?

A: The ATEM Mini Extreme's Ethernet output may be sent to the Streaming Bridge, so that an HDMI output may then be routed to the ATEM Mini Pro for the streaming process. ATEM Streaming Bridge units will be required to receive the Extreme's video output so that it may be converted to the desired connectivity protocol.

Q: 10. Related to a hardware functionality question on the Pro, will it be possible via firmware update to send a single fixed input to this device through Ethernet, and a switched program out through USB?

A: We can't predict if Blackmagic would be allowing that. For right now, this will just allow you to convert the IP signal into SDI and HDMI video.