Blonder Tongue Amcm Agile Micro Channel Modulator

Product Code: eq174478
Availability: In Stock

$1,062.00 $1,401.84

Qty

19 reviews Write a review

Description
Reviews (19)

The Blonder Tongue AMCM Agile Micro Channel Modulatorfrom Blonder Tongue AMCM Agile Micro Channel Modulatoris a module that installs in the MIRC-4D or MIRC-12D rack chassis, not included. It forms part of an RF modulation system for analog CATV applications, and supports an output frequency range of 54 to 860MHz.

Auto Audio Gain Control (AGC) SAW Filtering Die-Cast Chassis Requires MIRC-12D / MIRC-4D Rack Chassis Up to 12-Channels in 2RU Rack Chassis

Connectors
Input	RF Connector 1 x F type female Impedance: 75 ohm Return Loss: 24 dB return loss Input Level: 1.0 V peak-to-peak - 87.5% depth of modulation Frequency Response: 1.0 dB peak-to-valley - fv to fv+4.2 MHz Video-to-RMS Hum Ratio: 65 dB peak-to-peak Signal-to-Noise Ratio: 62 dB - weighted at 4 MHz bandwidth Differential Gain: 2.0% Differential Phase: 1.0° - 87.5% depth of modulation Chrominance / Luminance Delay: Per FFC requirements Mono Audio 1 x RCA female Impedance: > 10 ohm unbalanced / 600 ohm balanced Input Level: 0.5 to 4.0 V peak-to-peak - for 25 kHz deviation; constant AGC range Frequency Range: 50 Hz to 15 kHz Frequency Response: ۫ dB Total Harmonic Distortion: 1% at 25 kHz deviation Signal-to-Noise Ratio: 66 dB Over-modulation Threshold: 25 ± 2 kHz peak deviation
Output	RF Connector 1 x F type female Impedance: 75 ohm Return Loss: 12 dB return loss Frequency Range: 54 to 860 MHz - NTSC CATV channels 2 to 135 Power Level: +45 dBmV Power Level Range: 10 dB continuously adjustable Carrier-to-Noise: (In Channel): 63 dB Broadband Noise (4 kHz bandwidth): -75 dBc at +45 dBmV output level Spurious Outputs: -60 dBc Aural / Visual Carrier Ratio: -11 to -19 dB continuously adjustable 4.5 MHz Aural Inter-carrier Frequency Tolerance: ±150 Hz; 32 to 122°F / 0 to 50°C FCC Aeronautical Channels: ±5 kHz; 32 to 122°F 0 to 50°C
General
Alarms / Monitoring / Control	Front-Panel Indicators Channel Number and Mode: 2-digit red LED display +100 Channels: Red LED Video Over-modulation: Red LED Audio Over-modulation: Red LED Front-Panel Controls Output Level: Potentiometer Video Level: Potentiometer Audio Level: Potentiometer Aural Carrier Level: Potentiometer
Power Requirement	100 to 240 VAC at 50 or 60 Hz
Power Consumption	5 W maximum
Operating Temperature	32 to 122°F / 0 to 50°C
Storage Temperature	-13 to 158°F / -25 to 70°C
Humidity	0 to 95% RH at 95°F (35°C) maximum, non-condensing
Dimensions	1 x 7.8 x 3.5" / 25 x 198 x 89 mm
Weight	0.8 lb / 0.4 kg
Packaging Info
Package Weight	1 lb
Box Dimensions (LxWxH)	10.5 x 4.3 x 1.2"

Prohibits commercials that accompany broadcast programs from having modulation levels substantially higher than the broadcast program; and having an average maximum loudness substantially higher than that of the broadcast program
Provides consistent audio levels among all broadcast programs on different channels and among different programs within the same channel

Modular design allows for deployment of 12 channels in a single 2RU rackmount chassis

Utilizes SAW filters for improved performance

Die-cast chassis for RFI immunity

Related Questions and Answers

Q: 1. Can this be used with Sony cameras?

A: Currently no, but they have mentioned that they'll add support for Sony along the way.

Q: 2. Where are the cables for this thing? 1C specifically. It should be the first thing listed in accessories, only 1 pops.

A: In the box, the Syrp Genie Micro comes with a Link Cable and a USB Type-C to Type-A Adapter.

Q: 3. What is the tested latency?

A: The average latency of the Teradek Serv Micro is 20ms.

Q: 4. Will this work with the Nikon D700?

A: This unit is not compatible with the Nikon D700.

Q: 5. Can this be powered via the USB port?

A: The Teradek Serv Micro will only output power from the USB port. The Serv is powered by NPF-L Sony batteries or a DTAP power cable that connects to the 6-28v barrel input. Also , in the box you will receive a 18W AC Adapter 12VDC wall power adapter. 6-28V barrel connector Sony L Series battery

Q: 6. Can I use it to remotely trigger video recording on Canon R5/R6?

A: The Syrp Genie Micro connected to the Canon EOS R5 or R6 Mirrorless Cameras does allow you to trigger video recording with the Syrp Phone App.

Q: 7. how many receivers can I use with one transmitter?

A: There is no limit to the amount of receivers usable with The Lectrosonics IFBT4 transmitter.

Q: 8. Can you set a timer for a long exposure, ex Setting an exposure for 2 minutes can you set a timer for the desired shutter speed?

A: Yes, when using the Syrp App to control a camera via the Syrp Genie Micro, you can set the shutter speed of the camera. The App allows for shutter speed adjustments from as low as 0.1 seconds to as long as a 12 hour bulb.

Q: 9. Is it compatible with Pentax K-x?

A: The Syrp Genie Micro is not listed as compatible with the Pentax K-x Camera,

Q: 10. Is this compatible with Canon EOS R7, 90D and/or 70D for both photographs and video usage?

A: The Syrp Genie Micro connected to the Canon R7 or 90D Cameras does allow you to trigger video recording with the Syrp Phone App. It is not compatible with the 70D.

Claiborne	29/09/2024
[5 W maximum] Much better picture than using VCR for modulator and Radio Shack RF switcher. No lines much better picture. I only use Blonder-Tongue for modulators. 5

Marcus	25/08/2024
[5 W maximum] I was seriously about 400ft away and the clients were still able to hear the mix clearly! Love this awesome device! My only complaint would be the antenna being on the bottom. It made securely placing it in my K-Tek Stingray Large Audio Bag a bit challenging as I have 5 other receivers in there with XLR cables and Remote Audio BDS Power cables attached to them. Have yet to get the Sound Devices SL-6 attachment for my Sound Devices 688. 5

TODOR	24/08/2024
[1 lb] absolute Chinese copy of Sachtler just better,yes Sachtler is made in Dominican Republic REGION this one in china,for small cameras is killer,head is extremely smooth ,only the caring case is its so,so. 5

D-Maub	12/08/2024
[0.8 lb / 0.4 kg] This mug gets the job DONE!! I think i have one of the cleanest, fullest sounds when i record my vocals.....and thats BEFORE i even EQ them in pro tools! Great job ProSonus! I LOVE it!! Come check out my music at @ ---LOL (shameless plug) 5

Dimitri	11/08/2024
[5 W maximum] I've been selling and installing both the RF only and RF+IP models of the ZVPRO since 2015. We had one power supply fail in that time frame. That unit was in a less than ideal location being bombarded with construction dust. The customer also had daisy chained power strips which I'm sure didn't help. That's it. We've had no other issues. All these units are still in service. 5

Joo Medeiros	11/08/2024
[0.8 lb / 0.4 kg] -Futebol . soccer Maracan 5

Stanley	05/08/2024
[5 W maximum] Reliable, clear sound. I am using 8 of these on stage. Get good reliable sound with no dropouts. Why pay more? 5

Scott Jetson	08/07/2024
[0.8 lb / 0.4 kg] Lectrosonics claims that their products are made by fanatics and I believe them. Outstanding performance and range that eclipse the bargain brands. Wide range of frequencies available and very easy to scan locally for clear freqencies. lectrosonics service (for a fee) can also re-block your frequency group unlike other brands. 5

Jonathan	07/07/2024
[1 lb] This will be used on a Video Assist card to broadcast to my IFB's with picture and it is perfect for the job. With Lectro's usual cast iron manufacturing I feel safe placing this on someone else equipment cart and it working with no problems. Changing frequency is easy with this, but with my aging sight I only wish that the receivers would change as easy. 5

Church	12/06/2024
[1 lb] We use two of these for our digital signage around campus. These encoders have been up and running 24/7 for around 5 years and we've never had any issues. I've been really pleased with the continued support and firmware updates from ZeeVee as well as how easy it is to manage them from the web interface. 5