The white RDL D-RLC2 Remote Level Control Ramp Whitefrom RDL D-RLC2 Remote Level Control Ramp Whiteis a remote level control panel designed for RDL control modules. The D-RLC2 has two pushbuttons each associated with a LED. Pushing each button sends the appropriate signal back to the RDL control module. It can be installed in a standard US one-gang electrical box. The remote control is constructed on a steel frame. The electronics are fully protected within the rear enclosure. Connections are made through a rear panel detachable terminal block.

The D-RLC2 panel has a 10-segment LED display, which provides a visual indication of the level setting. The linearity of the display is tailored to produce indications consistent with the audible level. In systems where several control/level indication locations are needed, multiple -RLC2's may be connected to a single RDL control module. Push buttons are long-life switches mounted to provide protection from excessive frontal force.

10-Segment visual level display

UP and DOWN momentary pushbuttons

Related Questions and Answers

Q: 1. will this work for the new mirrorless EOS R?

A: I just tested the RC-6 on my R5 and it works perfect. But you have to use the 10 or 2 second self-timer drive modes.

Q: 2. Can this remote start recording videos?

A: Yes it does. I use this remote to start and stop recording videos with my 5DM3 and 5DM4 when they are mounted on my DJI Ronin. Don't forget: in your camera settings, go to Drive Mode , then select Self-Timer:2sec/Remote

Q: 3. will this work with the canon rebel T100/EOS 300D?

A: This remote is not compatible with the Canon Rebel T100.

Q: 4. What about 5Dsr is that work with it?

A: Depends on if you will need the extra resolution, for printing or something like that.

Q: 5. I have the T6i. How do I set this up so that it takes the photo after 5 secs, or can it only do 2sec? I have the camera set at 5 sec, but it still takes the photo asap so I don't have time to put my arm down for self portraits Thanks!

A: Unfortunately this is limited to 2 second delay or immediate shooting. The other option is to go with a wireless radio system like the Vello FreeWave Wireless Remote Shutter Release linked here. https://bhpho.to/3o4aG14. The benefit of this is it does not need to be in line of site. Or you can go with the Vello Wireless ShutterBoss III linked here. https://bhpho.to/3f3ghki. This allows you to set any duration delay timer you wish.

Q: 6. What are the 2 positions on the switch on canon rc-6?

A: If I remember correctly, the switch controls the delay in seconds before the shutter activates after clicking the remote.There are settings 0 or 2.

Q: 7. will RC-6 remote work with 1ds mark III?

A: No, the Canon RC-6 Wireless Remote Control is not compatible for use with the Canon EOS 1Ds Mark III DSLR camera.

Q: 8. Does it first focus with the half-press?

A: One correction I want to make, when putting my camera (5D mkIII) In Auto exposure mode, the camera will engage AF when pressing the remote control, and then take the image. When using Av mode however, the AF was not being engaged in my prior tests. So, this gives you the choice of pre-focusing prior and make sure the AF does not get done again, so have it done at the same time when pressing the R/C.

Q: 9. Can the battery holder be bought separately as a replacement part?

A: No, you can try getting it from Canon but buying a new one is your best option.

Q: 10. Can the RC-6 trigger the video on the eos 60d?

A: Yes it will, just make sure you enable the remote function on your camera.