Quested 10" 3-Way Powered Reference Monitor

Quested 10" 3-way Powered Reference Monitor

Product Code: eq174622
Availability: In Stock

$16,947.00 $23,217.39

Qty

11 reviews Write a review

Description
Reviews (11)

The Quested 10" 3-Way Powered Reference Monitoris Quested 10" 3-Way Powered Reference Monitorhighest-rated self powered monitoring system. The combination of Class A/B and D amplifiers provides the V3110 with 1000 watts of continuous RMS tri-amped power.

The monitor utilizes a 3-way speaker design with low frequency response down to 30 Hz from its custom designed, linear-travel, long throw 10" driver. The high frequency tweeter and mid range speakers are designed with Quested's low-fatigue soft-dome technology, and are capable of adjusting for either horizontal or vertical positioning. A 24 dB / Octave crossover slope delivers improved drive unit efficiency.

The speaker monitor features user adjustable low, mid and high frequency filters. LEDs are provided to indicate power on/off, overload and thermal protection status. The V3110 was engineered to deliver a versatile, high power density in a reference monitor cabinet with a minimal footprint and size.

General
Drivers	Low Frequency: 1 x 10" (25.40 cm) Mid Frequency: 1 x 3" (7.62 cm) High Frequency: 1 x 1.125" (2.86 cm)
Maximum SPL	120 dB
Frequency Response	30 Hz to 20 kHz, +/- 2 dB
Power Voltage	Factory set. Nominal 115 V or 230 V @ 50-60 Hz AC
Input
Connectors	XLR Female and 1/4" Jack combo
Impedance	10 k ohm / Electronically balanced, RF filtered
Wiring	Pin 1: Ground / Sleeve Pin 2: Hot / Tip Pin 3: Cold / Ring
Sensitivity	Rear-mounted 10 position rotary switch Calibrated in 2 dB steps
Filters
Low Frequency EQ	User, 4-position: -6 dB selector (for use with subwoofers) 0/+3/+4 dB
Mid Frequency EQ	User, 3-position selector: -1/0/+1 db
High Frequency EQ	User, 3-position selector: -1/0/+1 db
Power Amplifier
Low Frequency Output	700 watts RMS continuous
Mid Frequency Output	150 watts RMS continuous
High Frequency Output	150 watts RMS continuous
THD	>0.03% at levels up to 1 dB below clipping 20 Hz to 20 kHz Typical 0.005% at 20 watts/RMS @ 1 kHz
Hum & Noise	>-100 dB referred to clipping
Indicators
Power On Mode	Front blue LED indicates Power On Flashes during warm-up cycle
Overload	Front LED flashes red Indicating B below signal clipping
Thermal Protection	Front LED turns red, signal is muted Amplifier switches to Standby during thermal protection cooling cycle
Dimensions & Weight
Dimensions	14.96 x 23.62 x 14.17" (380 x 600 x 360 mm)
Weight	85.98 lb (39 kg)

Quested's highest-rated self-powered monitoring system

3-way design with low frequency response down to 30 Hz from linear travel, long throw 10" driver

1000 Watt RMS from combination of Class A/B and Class D amplification

Quested low-fatigue soft-dome high-frequency and mid-range technology

Adjustable HF / Mid section to accommodate versatile horizontal or vertical positioning

Current-driven, floating drive stage Class A/B power for HF and Mid drivers

Dedicated 700 Watt RMS Class D amplifier for improved LF driver dynamics

24 dB/octave crossover slopes for improved drive unit efficiency

Very high-power density for cabinet footprint and size

Related Questions and Answers

Q: 1. Does it have horizontal flip for teleprompter use

A: Yes, Image flip (H, V, H/V) is supported.

Q: 2. Will this work with the RANE RE27 RTA EQ system?

A: Yes this or any other RTA mic will work with Rane RE27

Q: 3. Does this not come with any power source?

A: This monitor does not include batteries or a power supply. Here are links to a nice battery kit with the monitor along with an AC power supply. Battery Kit - https://bhpho.to/2wlW6Jg AC Power Supply - https://bhpho.to/2lIwtzC

Q: 4. Can this mount on a video camera?

A: It can if you buy the appropriate hot shoe mount, but I wouldn't recommend it because the sound is weirdd

Q: 5. Is this HDCP compatible, can it be used as a TV when connected to a TV cable box HDMI? How does the speaker sound?

A: This is not designed for home entertainment purposes. We do not recommend it for this case.

Q: 6. Does the RTA mic come with a case?

A: Yes

Q: 7. what is the HDMI output on this? 1080? 720?

A: The output is rated at HDMI 1.4, which means it should be able to handle UHD 4k at up to 30fps, along with 1080p and 720p.

Q: 8. The speaker yolk shown in the image is not listed as an item in the box. Does this speaker ship with yolk as shown?

A: The Galaxy hotspot yoke bracket is not included. It is available for purchase separately; B&H# GAYBHS.

Q: 9. If I have multiple drives connected to this unit and want to eject just one drive, does it eject the entire hub or just the selected drive?

A: It should eject just the selected Drive but if you are using this on a Mac you might want to reconsider. I had to quit using mine because it would randomly loose connections with various connected discs I sent it back for repair they sent me another same issue I kept getting disk ejected improperly messages on my Mac very frustrating

Q: 10. Is the bluetooth a reciever or transmitter? If it is a receiver, can you split the stereo signal between the two channel controls? Thanks.

A: The Bluetooth feature on the PA6BT Powered Hot Spot Personal Monitor receives an audio signal that is transmitted wirelessly via Bluetooth from another device to playback audio from the paired device. The Bluetooth input is separate from the two wired analog input channels and you can not split the Bluetooth signal between the two wired channels. However, if the playback device you are using has a wired output in addition to Bluetooth, you can send the output from the device using a cable. Depending on the device, it may be possible to split the stereo signal with a Y-cable. Please contact us through live chat or by phone to provide more details so we can assist you further with your setup to determine what type of adapter you may need to use with your device for a wired connection.

William	21/08/2024
[120 dB] I purchased a second BR-10 to complete a PA system I use with a Fender guitar/Yamaha modeling amp combo. I get the sound I like and then let it rip. Clean, powerful and impressively responsive across the entire frequency range. Way more than enough for 1500 sq ft of audience (~200 people). Can switch to pure PA use without problems and nobody is going to gripe about this rig. Wish I had this setup when I started doing gigs. 5

Vladimir	18/08/2024
[120 dB] Real dope sound i love it 5

Kenneth	24/06/2024
[120 dB] I purchased a pair for mixing. These are very clear and precise. I look forward to using these more, as I have only had them a couple of weeks. 5

Vladimir	19/06/2024
[120 dB] Soud really dope! 5

vic	18/06/2024
[120 dB] I bought a pair of these to build a lightweight, yet powerful stereo keyboard amplification rig for my stage setup. They work perfectly for this with plenty of volume and clarity. I use a Yamaha CP88 Stage Piano and a Hammond XK1-C plugged in to an Alesis Multimix 8 channel mixer. The onboard Leslie effect on my Hammond unit sounds amazing with this setup. B&H Photo and Video delivered these units precisely when promised. Could not be happier! These speakers are a splendid value. 5

Christopher	21/04/2024
[120 dB] I bought a pair of the 10" speakers to provide sound in my basement for DJ practice mixes and to make my Peloton bike experience rock. It does that very well using only a fraction of its full power. I connected everything through a Yamaha MG10xu mixer. I have not taken the speakers outside yet, but they should power a backyard party and make the neighbors stand up and notice. The speakers are rugged, lightweight for the sound they produce, and priced well. You can certainly get better and louder sound, but you will pay at least double. 5

bxn_74	19/04/2024
[120 dB] Good customer service via live chat.� Item arrived as scheduled and described. 5

anyonymous	18/04/2024
[120 dB] If you need a passive near field studio monitor a little like Yamaha NS10s but with a nicer sound these are your babies! They have low distortion and a really nice high end and not harsh but also retain a very workable low end which makes mixing a breeze. I use them everyday as a mixer in Los Angeles. 5

Dave	14/04/2024
[120 dB] I had experience with using the 12 and 15 inch version of these speakers earlier this year with a band I was playing in, and when the need arose for my jazz duo to play an outdoor concert, I got a pair of these. I auditioned them at home for a week, and found the sound to be expansive, clear, and full-range. I used them for the first time this past weekend at an outdoor fund-raiser concert, and they performed magnificently. For once, vocals and my partner's trumpet were clear and cut through the mix. I ported my piano and my backing tracks thru it as well, and everything sounded balanced and clean. This allowed us to use my amp/powered speaker as a monitor, so we had the best of both worlds here. I cannot recommend these speakers enough. They are extremely lightweight given their quality, which is a must for me, and while they were not cheap, they are a great value, costing less than comparable speakers of other, famous brands. The other speakers I considered were heavier and just as expensive, and I doubt they would have sounded any better. And I am considering getting a third one of these to use as a floor wedge monitor for larger venues and larger bands. I'm happy with these and if you need a larger-sized speaker, the 12 and 15 inch variety are also a best bet. 5

anyonymous	13/04/2024
[120 dB] Bought this to compliment my Yamaha DGX-650 keyboard, and it works exactly as designed. Plugged it in to my keyboard headphone jack and adjusted the volume - viola ! I will someday upgrade to a larger unit when performing, but for now this meets my needs perfectly for practice - not too large, not too small, just enough power to fill a large room with legendary Yamaha sound. I may even add another one just because.... A bit pricey, but you get what you pay for. This unit rocks ! 5