The empty Mil-Standard Watertight Case 6" Deep from SKB is made from an injection-molded high-strength polypropylene copolymer resin that is not only impact-resistant, but UV, solvent, corrosion and fungus-resistant. The molded-in hinge provides additional strength. It features a gasket for watertight security up to approximately 3'. This case is typically used to store, and transport delicate equipment such as cameras, electronics, mics and mixers, cables, or musical equipment. This case is empty and does not included any foam or dividers.

Access to the interior is via two trigger releases with locking loops that will accept user-supplied locks. An equalization relief valve protects your gear especially against changes in pressure such as when you're on an airplane. For portability, there's a snap-down rubber molded cushioned handle.

Holds Delicate Electronics,Cameras,Mics    Gasketed, Waterproof, Airtight    Automatic Pressure Equalization Value    Injection-Molded Polypropylene Resin    UV, Solvent, Corrosion, Fungus-Resistant    Trigger Release Latch System    Accepts User-Supplied Lock    Molded-in Hinge    Snap-Down Rubber Cushioned Grip Handle

Related Questions and Answers

Q: 1. Is this a TSA-approved overhead bin size (like the Pelican 1510 and 1535)? I already have issues with my over-stuffed Think Tank Airport Security bag.

A: The maximum dimensions for a carry-on bag are 9 inches x 14 inches x 22 inches (22 cm x 35 cm x 56 cm), including handles and wheels.

Q: 2. I would need something like this, with these dimensions, but without the hard case, and the inserts would need to have a zipper on top. SKB 3I-1610-5DT Mil-Std Waterproof Case 5" Deep with Think Tank Designed Dividers (Black)

A: The closest option would be the Dot Line StowAway Insert Gear Case, BH # DOP300 https://bhpho.to/3EUwMe2

Q: 3. Will this case fit the Sony nx5u comcorder?

A: Hello Jian Unfortunately, from the dimensions found online it appears that the depth will be an issue so this case wouldn't fit.

Q: 4. Do they make a lid organizer that works with this case?

A: Unfortunately, there is no compatible lid organizer for this particular case.

Q: 5. Is this unit coming with layer foams ? I heard that trying to fit a Yamaha DTX 12 (with no clamps) was a tight press down for the covers and probably you need to remove a layer for an accurate fit and lid closure ?

A: Hi Jayaraj, The foam is glued into the case. This was specifically designed around the Yamaha DTX 12 and should fit with no issues. You do want some compression when closing the lid so the equipment does not shift around. We do offer the same sized case with cubed foam if you would rather create your own interior. It is our 3i-2015-7B-C. Thank you,Will

Q: 6. Will the cut-out in this case fit the GoPro Hero4 Black camera?

A: Yes it worked great. Trust any case from skb, to quality.

Q: 7. Will this case work and fit as an airline carry on. Thnx.

A: Each air lines have their own size specifications so it is a good idea to contact the specific airlines for that.This is around the size the bag can be at the largest, The maximum dimensions cannot exceed any of the following measurements: 22 long x 14 wide x 9 tall or 115cm (56 x 36 x 23 cm). The case you are referring to is, 19.00 x 14.38 x 8.00 (48.26 x 36.53 x 20.32 cm). So it is just a bit too wide.

Q: 8. Will a 15 inch MacBook Pro fit in the backpack?

A: You can fit a MacBook Pro into the case.

Q: 9. What are the wheels like? Are they like rollerblades or like the Pelican cases?

A: SKB iSeries 2011-7 Case come with rollerblade wheels.

Q: 10. I have two 5Ds (Mark II & Mark Iv) without battery grips. Can they stand up straight in the case even if I have a laptop in the lid? Can I squeeze in both my 15" mac and IPad Pro into the lid? Thanks

A: Being that the depth of the case is 7.5 inches and your camera only sit about 4.5 inches high, you can still fit them which your 15" Macbook is stored in the lid. However, adding the iPad Pro may take away the extra space.