This Baby Pink Beech Photo Frame 16x24" Acrylic Glassfrom Baby Pink Beech Photo Frame 16x24" Acrylic Glassis a solid beech wood frame that holds a 16 x 24" image behind an acrylic piece of glass. It features a frame width of 1.4" and can be hung up using the included wire kit.

Holds 16 x 24" Photo    1.4" Frame Width    Solid Wood & Acrylic Glass    Wire Kit for Hanging

Related Questions and Answers

Q: 1. Is the middle pin removable?

A: All of the studs are welded in place.

Q: 2. Can it accept a long stud? Some are blocked so I was wondering whether this one can do it or not

A: The Kupo Baby Stand Extension (18") has a standard 5/8" receiver and on the image four you may see how it fits the Baby Pin of Kupo light stand.

Q: 3. Hello, will this fit and tighten securely on atop a C-Stand?

A: Yes, this has a 16mm connection point which is what is on top of a C-Stand

Q: 4. What's the load capacity?

A: The Impact Baby Triple Header is made of steel, so it's especially strong. However, the manufacturer does not list a specific weight capacity. Balance likely would be more likely to be an issue than weight handling since typical C stands only take about 22 lbs. anyway.

Q: 5. Is this compatible with the inovativ cart c stand clamp holder?

A: No, the Matthews Telescopic Baby Stand Extension is too small for the Inovativ C-Stand Storage Clamps.

Q: 6. Does the 5/8 stud for mounting lighting fixtures have a hex cut to prevent rotation?

A: Yes, the Kupo Photo Baby Boom offers a finished hex cut on the 5/8 stud.

Q: 7. Would anyone know and or can confirm the size of the knob used to secure the this extension arm/tripe header? 3/8?

A: the size is 5/8"

Q: 8. Is the listed minimum height with the center column raised or lowered?

A: The Kupo High Baby Stand (13.75') minimum working height is 55.5" / 141 cm.

Q: 9. Can you remove the knob and use the triple header on a combo stand with a Junior receiver?

A: Yes, the Impact Baby Triple Header has Combo 1-1/8" Pin / 5/8" Receiver for mounting.

Q: 10. What size thread is the knob to secure this to a 5/8 stud? If you were to purchase a replacement knob, what size would you buy?

A: Unfortunately, Impact does not publish the thread size of the locking knob of this header. The knob can be obtained through Impact directly as a replacement part by calling 1-212-594-2120.