The Roto Mil-Std Waterproof Case 24" Deep with Layered Foam from SKB is a rugged and durable case for your photo, video and audio equipment. It meets ATA (Airline Transportation Association) standards. This linear low-density polyethylene case contains layered convoluted foam for product protection. It's ATA (Airline Transportation Association) rated; water and dust tight, and made to take a beating. It also comes with a handy ambient pressure equalization valve. The case is carried by spring loaded, rubber over-molded handles. The case is impact, UV, solvent, corrosion and fungus resistant.

Rotational molding is a 3-stage heating process that results in evenness all around the edges of the case. The polyethylene material is inserted into a mold, and then gradually rotated until the material sticks to the edges of the mold in an even pattern. Once cooled, this plastic material forms a strong bond that minimizes sagging and potential collapse.

Holds Delicate Electronics,Cameras,Mics    Gasketed, Waterproof, Airtight    ATA Rated    Protective Foam Layers/Impact-Resistant    UV, Solvent, Corrosion,Fungus-Resistant    Ambient Pressure Equalization Value    Spring Loaded,Rubber Over-Molded Handles    Recessed Carry Handles    Rotationally Molded Polyethylene

Related Questions and Answers

Q: 1. Is it possible to remove the dividers?

A: Yes, the Think Tank insert in the SKB iSeries 1914N-8DT Waterproof Case with Think Tank Dividers (Black) is removable.

Q: 2. Will Sennheiser g3 or g4 wireless hand held mics fit in this case?

A: This case has cut-out spaces that will accommodate four Sennheiser handhled transmitters.

Q: 3. Do they make a lid organizer that works with this case?

A: Unfortunately, there is no compatible lid organizer for this particular case.

Q: 4. What are the exterior dimensions?

A: Exterior Length:21.26 in Exterior Width:16.75 in Exterior Depth 9.83 in Exterior Cu. Volume: 2.03 cu ft

Q: 5. Has anyone had success adding a lid organizer to this case? If so, which one? Thanks!

A: Pelican lid organizers are compatible only with Pelican products.

Q: 6. I am interested in the SKB Roto-Molded Tripod Case (24 Tall). Would two tripods (each under 23 inches tall) and two ball heads not attached fit in this case?

A: Hi Lynette, It depends on the diameter of the tripod legs to judge if you have enough room for the two ball heads. If you have tripods for still cameras most likely they will fit as they tend to be smaller than tripods for video. Two tripods each under 23 inches should fit no problem unless the diameter of the legs closed is over 6 per tripod. To verify you could use a piece of gaffers tape and tape the the two tripods together and measure. Thank you,Will

Q: 7. Will this case work and fit as an airline carry on. Thnx.

A: Each air lines have their own size specifications so it is a good idea to contact the specific airlines for that.This is around the size the bag can be at the largest, The maximum dimensions cannot exceed any of the following measurements: 22 long x 14 wide x 9 tall or 115cm (56 x 36 x 23 cm). The case you are referring to is, 19.00 x 14.38 x 8.00 (48.26 x 36.53 x 20.32 cm). So it is just a bit too wide.

Q: 8. I would need something like this, with these dimensions, but without the hard case, and the inserts would need to have a zipper on top. SKB 3I-1610-5DT Mil-Std Waterproof Case 5" Deep with Think Tank Designed Dividers (Black)

A: The closest option would be the Dot Line StowAway Insert Gear Case, BH # DOP300 https://bhpho.to/3EUwMe2

Q: 9. are the dividers removable or adjustable?

A: The divider's are removable, and able to sort however way best fit's your equipment.

Q: 10. TSA Locking latch kit for this particular model?

A: You could use a TSA Lock accessory with the iSeries DSLR Pro Camera case, yes.