[Tilt: 0 to 12°] This is a repeat buy. I have one at the office at work, and one in my office at home. I also have purchased one that is single swing arm for the detached office at home. This one has cable routing, holds 2 27" monitors with no sweat. If you are in the market for one of these, it works great.

[Tilt: 0 to 12°] This is perfect for my setup! I got 2x32 monitors from B&H, and had to get this stand since I wanted them stacked. This was pretty quick to put together, and quicker to setup on my desk.

[Landscape] Exactly what I needed, very good quality build parts, it let's you adjust the screens with many angle approaches, it even has a height adjustment for every screen mount so if your screens have a height difference due to a bigger frame or mount point you can adjust them all still to be the same height ( gives you an inch +/- of margin to play with) - not that common on these products.Note that if you plan not to attach the center pole to the table and simply place it as is with the base plate, you will limit yourself to the angle of how much you can turn the side monitors curved to your direction since the center-weight-point will be moved further then the base playe and it will fall forward. In my pictures you can see the maximum angle to curve without mounting the pole to the table.

[Landscape] There are negative reviews about this product that almost made me 2nd guess purchase. They describe this mount being top heavy. Using common sense and moving the mounting arms lower on the center arm completely remedied that, if it was even an issue in the first place. I have a 27in monitor mounted center with 19.5 in monitors mounted vertically on either side. I NEVER have had even one problem with balance. This stand is well made and does require some aggressive tightening of joints in order to secure the angles you want, but well WELL worth the price compared to other 3 mounts stands.

[Tilt: 0 to 12°] Best seller for good reason. Well built and nice install options. This will mount in a grommet hole for the most stable installation. I was prepared to do that. I didn't need to. The base is fine for my situation. Good fit and finish. I don't know why, but one monitor does sit lower, even though I have the adjusting screw to the max.


For the price, you cannot go wrong.

[Landscape] I bought my MI-2781 a month ago, love it and recommend it to my fellow engineers working from home. It is a great product for the price. I was concerned the weight of my two 24" DELL monitors would make the free standing V base front heavy and front tipsy. This has not been an issue. The moment arm distance from the center of the vertical post to the front fulcrum line of the V base is about 8" and the center of mass of my 2 monitors is about 5.5". See my attached diagram. It would be helpful if the Mount-It website would include the 8" forward moment arm length in their diagram.

I did have an issue with the MI-2781A Installation Manual which I suspect is common for most Dell monitors. Step 5 of cannot be performed after step 4 because the VESA mount on the back of my Dell monitors is recessed about a quarter inch. In other words, it uses a carpenter's mortise and tenon joint. This is common to most of the Dell monitors I have used. After the VESA compatible plate is attached to the monitor per step 4, there is simply not enough clearance to perform step 5.

Instead, I had to do the following.
- undue step 4 (remove the plate from the back of my monitor),
- perform step 5 (attach the 2 plates to the arms),
- new step (lay both monitors face down on the floor),
- perform step 4 (attach the VESA compatible plates to the back of the two monitors),
- new step (lift and set the entire V-base assembly on my desk),
- then continue with installation step 6.

[Tilt: 0 to 12°] I had 1 mounted monitor and two on stands, but limited desk space. This was an excellent solution. Very happy!