This Global Truss Quick Rig Clamp Blackfrom Global Truss Quick Rig Clamp Blackis a black aluminum alloy heavy-duty, wraparound, low-profile hook-style clamp with a load capacity of 550 lb. It features an M10 threaded mounting stud with a wingnut on its base.

Aluminum Alloy Construction    Heavy-Duty, Low-Profile Hook-Style Clamp    Load Capacity: 550 lb    M10 Threaded Base with Wingnut

Related Questions and Answers

Q: 1. does this clamp comes with an adapter bushing?

A: Yes it does, a 3/8 1/4 reducer. Just be sure and do not overlook it in the bubble packaging like I did initially. It is very small.

Q: 2. Is additional screw needed to mount to film CB-32?

A: In my FLM ball head, I turned the round plate and replaced it with the SRB-60 Quick Release Clamp using the screw that was attached to the FLM ball head. I only strengthened with the thread glue the connection of the screw with the ball head and screws with the SRB plate

Q: 3. Will this fit on the Arca-Swiss Monoball P0? I know the 60mm diameter is a perfect fit, but I'm worried about the knob on the clamp clearing the lever on at the top of the P0. I know Sunwayfoto makes a clamp specifically designed for the A-S P0 that has an extra-long clamp knob so that it extends beyond the possible obstruction of the P0's top lever ... do I need something like that, or will this FLM SRB-60 be fine?

A: We see no issue if you use this with the Arca-Swiss Monoball P0 with Panning System B&H # ARMPOPS. In fact, we are of the opinion that this clamp will work better than OEM or other 3rd party clamps.

Q: 4. Is the knob on the side the same height as the clamp? Could the knob be adjusted while mounted flush to a table?

A: Knob is lower than the clamp. the clamp would need to be elevated for the knob to turn and for the clamp to be level.

Q: 5. What is the spacing of the bottom mount holes in millimeters? Curious if this can be direct-mounted to Arri plates.

A: The FLM QLB-80 quick release clamp has each of the mounting points spaced 12mm apart.

Q: 6. Will this work with Peak Design arcs plate for capture?

A: Yes it will.

Q: 7. Will this clamp modify a FLM CB-32 head to have a Quick Disconnect system?

A: Hi,Yes it will, but you should observe that the safety pin is for FLM plates and not necessarily compatible with other Area-Swiss plates. I own a RSS L-plate for the Oly OM-D E-MII and the pin is annoying. Perhaps the pin could be knocked out. You could also consider a RSS QR instead. Google that combination. Either way you should apply a locking glue to keep it securely in place. FLM has a guide for that.

Q: 8. Will the locking pin mechanism work with the Feisol QP-144750 QR Plate?

A: Yes. No problem great fit

Q: 9. Can the locking pin be removed?

A: The locking pin on the FLM QLB-80 Quick Release Clamp cannot be removed. However, if you squeeze the pin between a pair of pliers and push it down into the body of the clamp, the locking pin will be ineffective and out of the way.

Q: 10. does this come with an adapter bushing?

A: The QRC-50 does come with a 1/4 to 3/8 adapter