Use a tripod head with a 150mm ball base on your Dana Dolly 150mm Ball Mitchell Adapterwith this 150mm Ball to Mitchell Adapter. This hard anodized aluminum adapter allows for leveling a 150mm ball base head and will also affix to other standard Mitchell mounts.

Use 150mm Ball Base Video Heads    Also Works with Standard Mitchell Mounts

Related Questions and Answers

Q: 1. How long is each pipe? What is the total maximum length of the assembled track?

A: This kit comes with six 39" lengths of schedule 80 aluminum pipe. That would give you 117 inches for each side of the dolly track, which is just a bit under 10 feet of length.

Q: 2. What is the distance between the center of each pipe? Trying to figure out how wide it is. Want to run it through a car window.

A: The track width on centers for the Dana Dolly Universal Track End Bracket is 300mm.

Q: 3. Can you combine two kits to get 18' of track?

A: Yes, you can combine two kits.

Q: 4. Does this product only come with only one track end? or does it come with a pair?

A: The Dana Dolly Universal Track End Bracket (B&H# DADDUTE1) is a single track end bracket and not a pair.

Q: 5. Are the threads etched on to the outside of the pipe or does this come with threaded connectors?

A: the pipes have a thread cut inside, then they machined nipples with 2 male threads on them to join the tubes. you keep the nipple mounted on one side, and there is a protective rubber cap for when not in use.they are awesome for when you need to be moving around location, rather than dragging long pipe around.the threads are a little fine, be careful getting them started so you don't strip them.

Q: 6. Will a manfrotto 501 fluid head fit on here?

A: The Manfrotto 501HDV head has a 3/8 -16 thread. This system uses 75mm, 100mm and 150mm Ball Base Heads. You could however use a 501HDV on it, you'd just need 75mm ball adapter like B&H # MA520BSH.https://bhpho.to/2xdormd

Q: 7. how well would 6ft-10ft of PVC Schedule 40 Pipes hold up?

A: That depends on how much weight you are putting on the Pipes and how you intend to use them. If you plan to lay your dolly track on the floor for instance 6-10 feet probably isn't going to be a problem, however, if you plan to elevate the dolly then 6-10 feet will become very problematic. PVC Pipes are known to flex and break therefore you'd have to be extremely cautious about how and where you apply your supports. In addition to that, the heavier the payload the more cautious you have to be about how and where the supports are located. It is safest to use metal tracks if available at that distance.

Q: 8. this adapter include in package rental kit universal and this adapter fit to tripod head oconnor 150mm mitchell?

A: You can fit this adapter to a Mitchell head to accept a 100mm ball base head. Since we are not sure if we have answered your question, please email us at provideo@bhphoto.com.

Q: 9. How many end caps does it come with?

A: Each pipe had a pair of plastic end caps, so the kit has twelve in total.

Q: 10. What type and size of pipe "track" should be used?

A: The Dana Dolly Hi Hat Universal Kit (B&H# DADDHHUK1) may be used with pipe that is 1.5 to 1.9 inches (3.8 to 4.8 cm) in diameter. Schedule 60 steel pipe is enough for most uses, but if you will be using an especially heavy load then schedule 80 could be used.