The Dana Dolly 6" Mitchell Riser Plate for Filmmakingis suitable for use on your dolly or jib with a standard Mitchell mount and provides a fixed 6" rise. It is made from CNC machined 6061 aluminum and hard anodized black for wear and corrosion resistance. It supports up to 100 pounds and the base features a removable guide bolt.

CNC Machined Aluminum    Raises Mitchell Plate by 6"    100 Pound Load Capacity    Removable Guide Bolt    Made in USA

Related Questions and Answers

Q: 1. What is the distance between the center of each pipe? Trying to figure out how wide it is. Want to run it through a car window.

A: The track width on centers for the Dana Dolly Universal Track End Bracket is 300mm.

Q: 2. What type and size of pipe "track" should be used?

A: The Dana Dolly Hi Hat Universal Kit (B&H# DADDHHUK1) may be used with pipe that is 1.5 to 1.9 inches (3.8 to 4.8 cm) in diameter. Schedule 60 steel pipe is enough for most uses, but if you will be using an especially heavy load then schedule 80 could be used.

Q: 3. Will a manfrotto 501 fluid head fit on here?

A: The Manfrotto 501HDV head has a 3/8 -16 thread. This system uses 75mm, 100mm and 150mm Ball Base Heads. You could however use a 501HDV on it, you'd just need 75mm ball adapter like B&H # MA520BSH.https://bhpho.to/2xdormd

Q: 4. how well would 6ft-10ft of PVC Schedule 40 Pipes hold up?

A: That depends on how much weight you are putting on the Pipes and how you intend to use them. If you plan to lay your dolly track on the floor for instance 6-10 feet probably isn't going to be a problem, however, if you plan to elevate the dolly then 6-10 feet will become very problematic. PVC Pipes are known to flex and break therefore you'd have to be extremely cautious about how and where you apply your supports. In addition to that, the heavier the payload the more cautious you have to be about how and where the supports are located. It is safest to use metal tracks if available at that distance.

Q: 5. Does this product only come with only one track end? or does it come with a pair?

A: The Dana Dolly Universal Track End Bracket (B&H# DADDUTE1) is a single track end bracket and not a pair.

Q: 6. diameter of the pipe?

A: These are schedule 80 aluminum pipes at 1 1/4".

Q: 7. Hello, does this adapter attach to the dana dolly plate with screws?

A: The Dana Dolly DD75ADPT1 Mitchell to 75mm Ball Adapter does not attach to the Dana Dolly plate with screws.

Q: 8. So, can I mount this to a Mitchell Riser Plate? And how would it mount securely in place?

A: Yes you can mount the Dana Dolly 100mm Ball to Mitchell Adapter to a Mitchell Riser Plate. A large washer fits and locks underneath the Mitchell Plate.

Q: 9. How do the pipes connect? Are they threaded on both ends?

A: Yes they are threaded on both ends - male on one end and female on the other. Great kit BTW, and you get real personal service from the owner at Dana Dolly.

Q: 10. How long is each pipe? What is the total maximum length of the assembled track?

A: This kit comes with six 39" lengths of schedule 80 aluminum pipe. That would give you 117 inches for each side of the dolly track, which is just a bit under 10 feet of length.