The WL436 Series Long-Range White Light Illuminator from Iluminar is a visible light illuminator for surveillance cameras. This illuminator features high-power SMT-enabled (Surface Mount Technology) LEDs with current-limited integral control circuitry. It provides illumination to a distance of 92' at an angle of 120°. It also has a built-in photocell and comes with a wall mounting bracket. The IP67-rated and vandal-resistant illuminator can be used outdoors. The hardened housing provides protection from harsh weather conditions and rapid temperature variations ranging from -58 to 140˚F (-50 to 60˚C).

Long range white light illuminator with SMT LED technology

Provides visible light for surveillance cameras

Illumination range up to 92' (28m) at an angle up to 120°

318' (97m) horizontal field of view

Low power consumption of 36W

IP67 weatherproof rating

Built-in photocell with IR on/off

Telemetry input for remote switching

High PoE

Related Questions and Answers

Q: 1. Is B&H selling the newer AC-LR units (datecode 1638 and beyond) that are capable of 802.3af PoE or do they still require 24V?

A: Yes, the Ubiquiti Networks UAP-AC-LR-US 802.11ac Long Range Access Point B&H # UBUAPACLRUS is 24V but it can be used with PoE.

Q: 2. What's the size of the external power jack?

A: The size of the power jack is not listed. However Ikan offers both D-Tap and AC Power cables for this light if needed. AC Adapter for Light - https://bhpho.to/2YjI8mG D-Tap Cable for Light - https://bhpho.to/2pE3Y5M

Q: 3. Does it fit two SHAPE Low-Boy Double Riser Stand (Black/Chrome, 6.9')?

A: The Impact Long Light Stand Bag (52") is not big enough to hold 2x SHAPE Low-Boy Double Riser Stand (Black/Chrome, 6.9'). The Lightware C6150 Stand Sack (SHLBDR6) is big enough to carry two of them.

Q: 4. I purchased Pearstone 50' Cat6 Snagless Patch Cable (it was recommended) 1. Is the the correct cable? 2. Will the 50' length reduce strength?

A: 1) Yes. That cable is perfect. If anything, it's overkill but it will definitely work without issue.2) No. I think you could theoretically use up to 300'. I have had issues with a cable getting longer than 200' but I have many of these AP's on cables well over 100' without issue so you should be fine.

Q: 5. Will it fit 1 or 2 C stands?

A: The following unit will only accommodate 1 full c-stand system.

Q: 6. When I plug in the battery charger, it shows a red light. After several hours this light is still red. Does the charger light change to green when fully charged? How long should this take?

A: The batteries need to be charged on a separate charger for this light. It uses L-series batteries, which require a specific charger and depending upon the size of the battery, charge times can vary anywhere from 2 to 6 hours, depending on the model and brand of charger-- some even longer.

Q: 7. How long is the POE cable which connects this Unifi unit to the POE adapter?

A: The Ubiquiti Networks UAP-AC-LR-US 802.11ac Long Range Access Point BH #UBUAPACLRUS does not include any Ethernet cables. If you are referring to the power cord for the PoE injector, it is approximately 1.5'.

Q: 8. Has anyone upgraded from the previous non-AC LR units? Are the mounts the same or do you need to redrill the wall?

A: The mount plates are indeed different for the UAP-LR and UAP-AC-LR. Of note, the UAP-AC-LR access points are 25 mm (0.98 inches) smaller than the older UAP-LR access points.

Q: 9. Will multiple access points allow for seamless roaming within the covered area?

A: Yes, that's the whole philosophy behind UniFi. A suite of UniFi APs, that can include mixed models and mixed generations, properly configured by a common Controller, allows seamless roaming across overlapping AP coverage areas.

Q: 10. Is this rated to be outside?

A: No, this is not a outdoor model. BH #UBUAPACMUS is rated to be outside