Simplify your in-wall cable runs with this NTW Pre-Configured Customizable UniMedia Wall Plate. It is pre-configured with VGA, 1/8" audio, RCA composite video, RCA stereo audio, and USB pass-throughs.

Single-Gang Customizable Wall Plate    Pre-Configured with Select Terminals

Related Questions and Answers

Q: 1. Ok so I read here that the Solo streams to the solo portal at a set 5 secs delay. The stream is then sent to whatever destination we requested. OK, with that said, does that mean there are additional latency delays? So a 5 second delay and then the destination delay? IF that is what I read what is the total delay for the latency? That might make it harder for LIVE Q&A engagement.. Thanks for any feedback

A: There may be additional delays depending on the strength of the network signal on the other end. However you would need to test this out to see what those additional delays may be.

Q: 2. It reads the item is 12" long, does it only make one ring or can you make more?

A: This is 12" long, which is enough for a 4" diameter lens size. This really is only for a single lens.

Q: 3. Will this fit the Manfrotto 501HDV?

A: I have the Manfrotto 502HD, Benro S8 and Shape577 and this plate fits them all.

Q: 4. Is it possible to buy a matching receiver (clamp) for this plate, or is there a compatible Benro or Arca Swiss receiver that this will fit?

A: The Manfrotto 577 rapid connect adapter is compatible with this plate. It comes with the MA501PL plate but will also fit the 500PLONG plate. Please note, while it will fit width-wise, the receiver will be slightly shorter than the plate but it will still fit. a href= http://www.bhphotovideo.com/c/product/241139-REG/Manfrotto_577_577_Rapid_Connect_Adapter.html target= _blank http://www.bhphotovideo.com/c/product/241139-REG/Manfrotto_577_577_Rapid_Connect_Adapter.html/a

Q: 5. Will this plate fit MVH502AH tripod head?

A: It is compatible. Have fun!

Q: 6. Will this fit the Manfrotto 504x head?

A: Yes, it will work.

Q: 7. Under In the Box it says a 3/8 -16 Camera Tie-Down Screw is included. However, looking at the pictures it looks physically impossible to put a 3/8 screw in the plate. Usually there is a rubber stopper and a large hole for plates that accept 3/8 . Can a 3/8 screw be used with this plate?

A: Yes, you can use the 3/8 and there is a rubber grommet in the end. you just can't see it in the photo

Q: 8. Does this plate have as much adjustment as the plate on the Manfrotto 502AH?

A: The Manfrotto 500PLONG Video Camera Plate (4.7") is slightly shorter than the Manfrotto 504PLONG (5.5") plate that comes with the Manfrotto 502AH head. Both are compatible with the Manfrotto 502AH head, but the 504PLONG would have a bit more length to move. https://bhpho.to/3hpe1oZ

Q: 9. Can this unit connect to wifi without a USB modem connected? We are looking to connect as wifi only. No bonding. No direct wire connection to a modem.

A: The unit also has a CAT5 connection. And if you are at a difficult site, you can mix all 3.

Q: 10. Will this plate fit the 502 manfrotto head?

A: Yes, all Manfrotto tripods from the older 710 HDV up to the 504, (maybe all), use the same size plate. Some are longer than others, but the height/width/design is the same.