The beige Sanken COS-11D Lavalier Mic for Sony Transmittersis a subminiature lav microphone designed to deliver clear, full-bodied sound and reliable performance, making it a popular choice among industry professionals in broadcast, TV, theater, film, videography, and more. 

Engineered to meet the standards of modern digital wireless microphone systems, the COS-11D is RF shielded to eliminate interference issues and ensure a pristine audio signal. The microphone capsule features a rectangular design that sits vertically, increasing the surface area and allowing this tiny mic to offer a rich, full sound that outperforms many larger models.

The mic's 50 Hz to 20 kHz frequency response rolls-off extreme low end and provides accurate, transparent audio reproduction with a small presence boost in the 6 kHz area for crisp, intelligible speech. With a forgiving omnidirectional polar pattern that picks up sound in a 360° pattern, levels stay consistent even when the subject turns away from the mic.

A water-resistant mesh screen protects against humidity, perspiration, makeup, bad weather, and other potential on-location issues, while the durable cable is also moisture-resistant and built to stay soft and pliable, even after extended use. This version of the COS-11D terminates in a locking 3.5mm connector and is wired for use with Sony transmitters. A metal windscreen, holder clip, rubber mount, and plastic case are included.

For Broadcast, Film/Video & Presentation    Omnidirectional for Consistent Levels    For Sony Transmitters with 3.5mm    -9 dB Reduced Sensitivity Level    Rugged 5.9' Cable Stays Pliable    RF Shielded for Digital Wireless    Water Resistant    Small Size Is Easy to Conceal    Requires 3 to 10 VDC    Includes Windscreen, Mount & Clip

• Sony: Works with Sony bodypack transmitters equipped with a locking 3.5mm connector, including the UWP-D and DWZ Series.
• Also works with many third-party wireless transmitters and portable audio recorders that are equipped to supply 3 to 10 VDC through a locking 3.5mm connector wired for Sony compatibility.

Related Questions and Answers

Q: 1. Will this enable dual recording on both the TX and camera possible at the same time?

A: Yes, you can record to the transmitter and send audio to the receiver of the DJI MIC 2 at the same time, when using the receiver mounted to the DJI Mic 2 MI Shoe Camera Adapter.

Q: 2. Is it going to be compatibile with Sony FDR AX 700?

A: The DJI Mic 2 MI Shoe Camera Adapter is only compatible with the following units: Sony ZV-E1, ZV E10 Sony a1 Sony a7C, a7C II, a7CR Sony a7S III Sony a7R IV, a7R IVA, a7R V Sony a9 II, a9 III Sony a6700 Sony FX30, FX3

Q: 3. Is it allowed live monitoring thru bluetooth headphone connection?

A: No, live monitoring can not be done via Bluetooth, only playback. The recording audio is output to the headphone jack, so you would need a wired connection to monitor.

Q: 4. Does this fit over the regular foam windscreen included with the mic or is made with the foam integrated with the furry similar to the rode videomicro's? Thanks!

A: This has open-cell foam inside to go right over the VideoMic NTG specifically.

Q: 5. Does this Rycote Softie Kit MFR #033395 work with Schoeps CMC641-- MFR #CMC641G SET?

A: Yes, the Rycote 033395 Softie Kit for Sanken CS-M1 Microphone with Windshield and Shockmount can also be used with the Schoeps CMC641 Set Colette Series Supercardioid Microphone.

Q: 6. What happens when the internal battery eventually fails?

A: If the internal battery for the Sony PCM-A10 Audio Recorder fails, you will need to contact Sony to inquire about battery replacement.

Q: 7. What is the largest size micro SDXC card that can be used?

A: Per the manual: microSDHC cards from 4 GB to 32 GB microSDXC cards of 64 GB or more

Q: 8. Would this fit a Rode NT5?

A: RODE NT5: Dimensions ø: 0.79 x L: 4.65" / ø: 20 x L: 118 mm Rode WS11: Compatible Mic Diameter 0.85" / 21.59 mm So this furry wind shield would be too large for the NT5 Use the correctly sized Rode WS8 Deluxe Windshield for NT5, NT55, and NT6 B&H # ROWS8: https://bhpho.to/30tEidL

Q: 9. Is there a way to record and use the unit when the USB connector is plugged in at the same time for extended recording? It says you can on Page 189 of the manual, but, there is no AC/USB accessory power and once the built-in USB connector is plugged in, the unit is disabled from use? How do you do this?

A: Battery Life (a built-in rechargeable lithium-ion battery) The battery life spans provided here are all approximate periods of time. For the battery life of the linear PCM recorder in any other mode, refer to the Help Guide. Recording: LPCM 96 kHz/24 bit: 15 hrs; LPCM 44.1 kHz/16:bit 20 hrs; MP3 192 kbps: 22 hrs; Playback with built-in speaker: LPCM 96 kHz/24 bit:9 hrs; LPCM 44.1 kHz/16 bit: 9 hrs; MP3 192 kbps:10 hrs; Music file (LPCM 192 kHz/24 bit):7 hrs Playback with headphones: LPCM 96 kHz/24 bit:18 hrs; LPCM 44.1 kHz/16 bit: 22 hrs; MP3 192 kbps: 25 hrs; Music file (LPCM 192 kHz/24 bit): 13 hrs Recording with REC Remote: LPCM 96 kHz/24 bit:10 hrs; LPCM 44.1 kHz/16 bit: 12 hrs; MP3 192 kbps: 12 hrs; Playback via BT connection: LPCM 96 kHz/24 bit: 14 hrs; LPCM 44.1 kHz/16 bit: 18 hrs; MP3 192 kbps: 18 hrs; Music file (LPCM 192 kHz/24 bit): 10 hrs https://www.bhphotovideo.com/lit_files/452717.pdf

Q: 10. Can I simply attach this to a shoe mount on the FX3 and use it?

A: Yes. The CS-M1 will work with the FX3