The tan E6 and E6i Snap-On Microphone Cable from Countryman E6 E6i Snap-On Replacement Microphone Cableis designed for use with the E6 and E6i earset microphones. It can be used to replace a cable in the event of a short or break and is an alternative to replacing the entire microphone.

It features a snap-on design that has a TA3F connector for use with Audix wireless bodypack transmitters.

1mm Diameter Aramid-Reinforced Cable    TA3F    Tan

These replaceable cables are available in various connector types to accommodate various wireless microphone transmitters. This cable features a TA3F connector for use with Audix wireless bodypack transmitters.

The replacement cables are available in matching E6 and E6i ear set colors. This cable is tan.

Related Questions and Answers

Q: 1. What's a good articulating arm for this ?

A: The choice of arm would depend on the item you wish to attach, the reach and level of adjustment you need when attaching to the Impact Super Clamp with Ratchet Handle BH #IMCC106R.

Q: 2. Is there a minimum power voltage for this unit? Can I use a 9-12v source?

A: Since this is designed for use with a specific battery, the Canon LP-E6 and the only voltage listed is 7.2 volts, I would have to say no. You would have to proceed at your own risk. If you wish, email us with your set up of power source, cable and camera you wish to power and we will see what answer we can find for you. provideo@a href= http://bhphoto.com target= _blank bhphoto.com/a

Q: 3. Can I use this to power a SmallHD 702 Bright from SmallRig's V-mount plate?

A: Yes, the SmallRig 2.1mm DC Barrel to LP-E6 Dummy Battery Power Cable (23.6") should be able to power the SmallHD 702 Bright via the LP-E6 port from the 8V DC barrel port of the SmallRig V-Mount Battery Adapter Plate with Dual 15mm Rod Clamp, BH #SM3203B.

Q: 4. Can it be used for a Samsung camera?

A: It can be used with any device that has a 1/4 inch screw mount, but this piece of equipment is not intended to be used with a camera, it is a gripping support not a tripod head.

Q: 5. Can I connect this to Blackmagic Design Video Assist 7" 12G, while the other end connect to Sony NPA-MQZ1K Multi Battery Adapter Kit? So I can power both my Sony camera and recording monitor from the multi-battery.

A: No, the SmallRig 2.1mm DC Barrel to LP-E6 Dummy Battery Power Cable (23.6") is incompatible with the Sony NPA-MQZ1K Multi Battery Adapter Kit.

Q: 6. Is there a minimum voltage to power this? Can I use a 9v-12v source?

A: Voltage has to be over 9V

Q: 7. Will this work with the r5c?

A: Yes it will.

Q: 8. Can I connect it to a Atomos power station?

A: Not that we are aware of. This product is for the IndiPRO Tools PORTA-PAK system. We are not aware of how it being able to work with other battery solutions. https://bhpho.to/2KfB5YJ

Q: 9. Does this work with Canon Mark IV

A: Yes it should. The 5D Mark IV uses the LP-E6 battery system, which is the kind of dummy battery this cable has.

Q: 10. Can I use this battery with a Canon R6II?

A: Yes, the SmallRig 2.1mm DC Barrel to LP-E6 Dummy Battery Power Cable (23.6") is compatible for use with the Canon EOS R6 Mark II Mirrorless Camera.