Finish your installation with a clean look with the black Whirlwind WP2B/2MW 2-Gang Wall Plate. It features a two-gang design with two Whirlwind WC3M male XLR terminals to pass your wiring through the wall, reducing the appearance of cable clutter.

2x Whirlwind WC3M Male XLR Terminals    2-Gang Design

Related Questions and Answers

Q: 1. If I have a core with a painted standard background attached, will this hold the weight of the canvas background?

A: This Impact Wall Mounting Kit would be able to hold a canvas background on an aluminum core safely below a width of 12 feet.

Q: 2. I have a 95 and 3/4 inch wall and want to mount an 86” roll. Will it fit with the varidrive ends, cardboard core and brackets? I know it is very tight, any way to fit it though?

A: No, you will not have room to install the Impact Varidrive system on a 95 3/4’’ wall.

Q: 3. What are some tips for keeping the paper from rolling onto itself when you roll it all the way up? The tension is great and everything works fine, just curious if I missed something or maybe doing something wrong. Do you add clips to the bottom of the paper to keep it tight/weighted when rolled all the way up?

A: You can use clips or a counter weight. https://bhpho.to/2kD2k4e

Q: 4. Does buying the metal chain version really make a difference?

A: Yes. Both systems work, but the metal chain has better build and durability and has decent tension. Also, I feel the weight of the chain helps the chain hang better and straighter. The plastic chain helps if you are on a budget, but it can seem too light at times. It basically comes down to personal preference.

Q: 5. For the metal chain, there are no instructions as to how to put it on the drive, as there are for the plastic ones. The plastic ones come opened up so they can be closed after threading. All I can figure out is that the varidrive has to be dissassembled to install the chain, Is that correct?

A: Yes, the black knobs unscrew allowing access for the chain to the gear.

Q: 6. Can these be mounted on stands?

A: Hi , in light stands no , there is some mount that you can use for that , but for me is better in the wall

Q: 7. How far away do I need to mount it for a 107 seamless paper?

A: If you are referring to how wide you need to set up the brackets it is just a touch wider than the roll of seamless.

Q: 8. How far out from the wall is the closest roll?

A: its about 4" long

Q: 9. Do these still come in sets of three? Also, what else do I need to buy to mount these to a wall. Thanks!

A: That which you see in the picture is a set for one roll of paper. If you want to operate 3 rolls of paper, you need 3 of those sets. The 2 white things in the picture fit inside the opposite ends of the cardboard tube and can be expanded to fit tightly inside it. Thus installed they become the axle and bearing for the paper roll and they must be supported by some type of wall mounted angle brace that you supply. Once you have a wall mounted support capable of holding the paper rolls, you will need to make an additional simple adapter to hold the axles in place on top of your support.

Q: 10. Can I order just the metal chains?

A: You may order the chains as a replacement part through Impact directly. Here is a link to their contact page: http://bit.ly/29CMpL0