[31 x 23.5 x 13"] is very good

[36 lb] Just got an M32 and searched everywhere for a case and then spotted this on a few sites. At first I was turned off because it was a special order and pictures didn’t show much but after talking to a sales rep he put my mind at ease. Also this is nearly $200 more on their competitors site and that confused me too but it’s the exact one and I’m not complaining.

Quality is great, casters and latches are better than I’ve seen on more expensive cases and doghouse even has the Midas logo etched into it. To be honest I was not expecting this to be so nice. I have yet to take it on the road but based on all the above, I’m sure it’ll be fine.

[35 lb / 16 kg] The TF5 goes above and beyond for its technology and performance. It is extremely easy to navigate through all of its complex features.

[36 lb] No blockage of any of the posterior inputs.
Well built.

[31 x 23.5 x 13"] Eu uso esse console em meus trabalhos em som direto, excelente maquina, portátil, facilita muito meu trabalho.

[36 lb] The qualities that I like about this case: -the top cover only goes in one way as the latches are oriented to know which way the board is front and back -you can remove the rubber foots via screw-driver if you like -the casters are nice and wide so that the bearings don't get abused too much from the weight -with the new board, there's a little bit of room under it, so we store additional cables and other simple accessories in there

[35 lb / 16 kg] We use this mixer for major events and a daily news program. It just works! I really like the GEQ mode for checking where instruments are in the mix.

[35 lb / 16 kg] Perfect for the M32R! It has plenty of handles to get the right grip when moving it around!

[36 lb] This case works quite well. I saw other cases for this mixer that weigh twice as much as the mixer. This weighs about the same as the mixer so it becomes a little heavy, but still manageable for one person. My only complaint is the feet. They are hard, smooth rubber, which is slippery. The case slides too easily on the table. I'm afraid it might get knocked off the table. I am still searching for soft, sticky rubber feet to replace them.

[31 x 23.5 x 13"] For a case made in China, this is still a really good quality build. While it's made for the Midas M32R, I purchased it for the Allen & Heath SQ-5 (it's a nicer board than the M32R for a whole host of reasons) because I wanted a foam lined case, not a hard rack rail and I haven't been able to find any other manufacturer making the case to accommodate the SQ-5. This case will do it with a little work, which is what I expected. Remember to save your Allen & Heath packing foam, then see my attached photo for details on how to make a SQ-5 fit nicely into this unit. Perhaps ProX will make an SQ-5 case as soon as that mixer gains popularity. Until then, my modification is really nice. (Note: out of the box, this ProX case looks like it will fit the M32R without any modifications.)