The Autocue SD/HD-SDI to Analog Converter | Video Signal Conversionfrom Autocue SD/HD-SDI to Analog Converter | Video Signal Conversionconverts SD and HD-SDI to analog component, S-video, or NTSC/PAL composite video. It is suitable for use with the Autocue v5.1S SDI QBox.

SD-SDI and HD-SDI Converter    Component, S-Video, and Composite Output    For Use with V5.1S SDI QBox

Related Questions and Answers

Q: 1. Am I able to split a 4K signal into 4 1080p quadrants for a video wall application? (Similar to the Datapath FX4)

A: Yes, you could use the Blackmagic Design Teranex Mini 12G-SDI to Quad SDI Converter for a video wall setup.

Q: 2. Does the RJ45 connection support video pass through? If I were to go SDI in and Cat 6 out to a video control that sends to an LED Wall?

A: The ethernet port is for software control only. It does not pass video.

Q: 3. What is the image quality like converting HD-SDI to HD Component? Are there any artifacts or a loss of resolution? I have an HD CRT that I'd like to use, but it only has analog HD inputs. Cheers!

A: HD-SDI Digital HD was a step up in image quality over Component Analog HD. So in a critical analysis, yes, you will see a slight difference. But for casual use, there is no loss in quality to the degree that it would interfere with your use or enjoyment of your CRT display. After all, it was what we had for years and were quite happy with it.

Q: 4. Can this unit be used to adjust the audio volume or do you need to attach an audio mixer for that functionality?

A: There are no audio level controls. Audio stays in the embedded data untouched.

Q: 5. Is the "SDI loop out" completely clean to feed a separate down converter to 1080?

A: I’m pretty sure it is. But I think you might want to look at a Decimator MD-HX. It has scaling and dual outputs.

Q: 6. Will this convert a 35mm film camera output (analog) to SDI signal (Digital) ?

A: No, this is a converter to go from SDI to analog. Here is a converter that will convert from analog to SDI: https://www.bhphotovideo.com/c/product/558906-REG/Blackmagic_Design_CONVMAAS_Mini_Converter_Analog_to.html?sts=pi&pim=Y

Q: 7. I need to convert analog video on a BNC to SDI on a BNC. Can I put analog BNC on the Y connector input and will it convert it to SDI?

A: No-Sorry this unit will convert SDI to analog. They do make a unit to do what you need. Blackmagic Design Mini Converter Analog to SDI B&H # BLASDIMC MFR # CONVMAAS2

Q: 8. Would this allow the SDI output from the Blackmagic talkback converter to interface over XLR to other intercom systems?

A: You can extract the Talkback audio in SDI 15/16 with this converter.

Q: 9. Can I connect my atem to this and send vga out to existing projector signal ?

A: This device will give you an analog composite or an RGB component output. We use this converter to feed the component input of our projector and it works great. If you only have a VGA input on your projector, you will need to convert the component signal to VGA before you can use it on your projector.

Q: 10. I have a Marshall CV226 3G SDI camera and a analog DVR. Will this convert it into a usable format for the DVR?

A: In a format of 59.94p, 1080p, the Blackmagic Design Mini Converter SDI to Analog will convert such a signal to an analog NTSC signal, which should then be accepted by an NTSC compatible analog DVR.