The Dana Dolly Anti-Tip Bracket Kit for Stabilityfrom Dana Dolly Anti-Tip Bracket Kit for Stabilityprotects your camera gear by helping to prevent the Dana Dolly platform from tipping off of the track. It includes two anti-tip brackets that attach to either side of the dolly platform that catch the track rail if the platform begins to tip. Also included is a center support for longer track runs. Rather than the rail clamps found on the standard center support, this center support features felt lining and freely rests underneath the track. The low-profile design allows for dolly platform clearance when the anti-tip brackets are attached.

Prevents Dana Dolly Tipping Off Rails    Two Anti-Tip Brackets    Low-Profile Center Support    Made in USA

Related Questions and Answers

Q: 1. Is there a version of this with a flight case?

A: We think you are thinking of these dollies. However, in order for them to fit in a reasonable case, they do not incorporate a high hat. https://bhpho.to/2kitBVS

Q: 2. 9' might be a little long for what I need. Is there a way to shorten it?

A: The track kit comes in sections, so use 1 section only.

Q: 3. Can you lay the tracks on the ground without using stands?

A: Yes, the dolly track holders can sit on the ground.

Q: 4. The 504hd manfrotto head fits in this riser?

A: This riser is for Mitchell Base Heads. For a 75mm head you would want a riser like the ikan IK-RSR6 Hi-Hat Riser (6") instead, BH #IKIKRSR6. https://bhpho.to/31tQKKZ

Q: 5. can that Reverse setup when wanna low angle?

A: For a low angle, you would want to use a shorter stand, such as a set of Avenger Combo Steel Stand 10s: https://www.bhphotovideo.com/c/product/611470-REG/Avenger_A1010CS_A1010CS_Ultra_Low_Boy.html/specs

Q: 6. What is the load capacity of this motor?

A: Kessler doesn't provide a load capacity for the motors on the Kessler Crane Motor Kit for Dana Dolly. The payload has more bearing on the type of track you have and the support for such and the payload above.

Q: 7. What type and size of pipe "track" should be used?

A: The Dana Dolly Hi Hat Universal Kit (B&H# DADDHHUK1) may be used with pipe that is 1.5 to 1.9 inches (3.8 to 4.8 cm) in diameter. Schedule 60 steel pipe is enough for most uses, but if you will be using an especially heavy load then schedule 80 could be used.

Q: 8. Can you stack these on top of each other to get double the height?

A: You can do a double if you need to. I did it many times.

Q: 9. How do you under sling this Dana?

A: You can put the Dana Dolly Hi Hat Universal Kit in an underslung position by first removing the low hat by unscrewing the thumb screws from the sled, flipping the low hat, and then securing the low hat by screwing into the 4 countersunk mounting points.

Q: 10. What is the distance between the center of each pipe? Trying to figure out how wide it is. Want to run it through a car window.

A: The track width on centers for the Dana Dolly Universal Track End Bracket is 300mm.