Professionals looking to suspend HDL 10-A speaker modules will be thankful for the RCF FL-B LGT HDL 10, a suspend bar capable of supporting up to six HDL 10-A modules. The bar is made from strong steel and includes a pole mount, a pickup tab with shackle, and a stacking bar (pins included).

Suspend up to Six HDL 10-A Modules    Strong Steel Construction    Scratch-Resistant Black Paint    Includes Pole Mount    Includes Pickup Tab with Shackle    Includes Stacking Bar    Pins Included

• Suspend up to 6 HDL 10-A modules
• Strong steel construction

Related Questions and Answers

Q: 1. Is this a power distribution switch?

A: The American DJ POW-R BAR RACK USB 10-Outlet 2-USB Rackmount Power Distributor is a power strip/distribution unit with eight switchable outlets and two always-on outlets.

Q: 2. It says for 1 hdl6.. so are 2 included? Or is it only one cover?

A: The RCF Protective Rain Cover for Amp Modules for 1 X HDL6 is a single rain cover for 1 RCF HDL 26-A 2-Way 2000W Active Line Array Speaker.

Q: 3. Does the third mic get mounted on the center screw after it comes through the bracket? There are the joints of the adjustable arms there, I'm concerned there isn't enough space or thread length left to mount a third mic there.

A: This is a stereo bar and is intended to hold two microphones.

Q: 4. How many volts is the AC power input? 110 or 220V?

A: The RCF NX15-SMA available here at B&H is 115VAC compatible only.

Q: 5. Which case shall I buy for this 9" T bar since the product doesn't comes with case ?

A: For the Auray LS-TBAR-9 DJ Light Stand with T-Bar (Black, 9'), a case that's at least 45" long and 6" deep and wide will hold it, like this case: https://www.bhphotovideo.com/c/product/119482-REG/Photoflex_TP_842_Transpac_Outbound_Bag.html/specs

Q: 6. I see the PR 63 Power Rack listed as a related product with these a lot. Do you need the Power Rack paired with these? Can I just have an edison to powercon adapter for these? Follow-up, does this affect the pass-through power in any way?

A: You can do powercon to edison here, there is no problem. Each element takes up 6amps so no more than 2 on a 15amp circuit. The power rack helps manage the power distribution when touring

Q: 7. would like to confirm, are the left and right mic mounts and knobs made of metal as appears in photo, also are they standard US mic thread (5/8 I think)? and, is the center bracket and hardware also metal?

A: Everything is sturdy metal except the part of the cap on the mic mount screw you turn to tighten. Even that is sturdy not cheesy. Standard thread to fit atop a mic stand. I mounted mine to a clamp. I had a little issue with the alignment of the clamp tightening screw and the nut on the center hardware making a little challenge to tighten, but even that was no big deal.

Q: 8. How many fully loaded cases can this model handle (prox x-rcf -alax4w)

A: According to the manufacturer, you can stack up to three of the ProX X-RCF-HDL6A LA X4W Flight Cases for 4 RCF HDL6-A Speakers that are fully loaded.

Q: 9. what voltage is applicable in USA for this unit ?

A: 110 to 120 VAC (50/60 Hz), 24 VDC

Q: 10. How many watts.

A: 2,500 W Peak / 1,250 W RMS