Convert 1 D-Tap output to 4 D-Tap outputs with the Wooden Camera 4-Way D-Tap Splitter Cable. Recommended maximum load is 10 amps. Voltage is unregulated.

Splits 1 D-Tap into 4    10 Amp Maximum Load    Unregulated Voltage

Related Questions and Answers

Q: 1. What is voltage regulated to (in an actual number, not a general “the correct voltage for the camera” statement). Is it 24V like the AC adapter?

A: The Wooden Camera D-Tap to DC Barrel Power Cable for Canon C70 has a regulated 19.5V output.

Q: 2. Does it have an screw holes at the back?

A: There are no mounting points on the Watson Pro D-Tap 1x4 Splitter Cable.

Q: 3. What voltage is it regulated to?

A: The Wooden Camera D-Tap to DC Barrel Power Cable for Canon C70 would work with the propter voltage for the Canon C70 camera which would be the following.(11.5 to 20VDC) Input.

Q: 4. Is this meant to be used to connect few dtap devices to single dtap power source?

A: Yes, this device will allow you to connect up to three D-Tap devices to one D-Tap output on a battery or other devices. This device can handle up to 10 amps across all three plugged in accessories (or per port when using just one). The three accessories must not draw more Amps than the D-Tap source can supply.

Q: 5. Is there anyway to mount this to 15mm rails?

A: We have touch fasteners you could use. https://bhpho.to/2uJsUxs

Q: 6. can this splitter be used for a FM/AM radio off a TV antenna system?

A: Yes. It can be applied to both radio and Tv applications.

Q: 7. Why can't I buy just one?

A: Yes. Please review the following item. IndiPRO Tools D-Tap Male to Female Rubberized Extension Cable BH #INPRORBB • MFR #PRORBB https://bhpho.to/3ut6HPe

Q: 8. Can I power the c70 with this cable and with an internal bp-a30 simultaneously? Will the camera draw power from this cable first

A: Yes, normally the power provided by the Wooden Camera D-Tap to DC Barrel Power Cable for Canon C70 would be used first if a battery was installed in the camera. Once removed the battery in the camera would take over.

Q: 9. Can I power both a zacuto gratical eye and a SmallHD502 using this adapter - most of these splitters are rated for max of 10W, whereas these two devices wils require approximately 13W at full tilt. If not this Watson Dtap splitter, has anyone used another splitter for greater than 10W draw successfully? Thanks!

A: I'm pretty sure the rating is in amps, not watts. 14.4 volts * 10 amps = 144 watts.

Q: 10. What is the difference between this SKU, INPRFPS, and IN15V4DT?

A: The difference between the IndiPRO Tools 15V, 10A AC Power Supply to 4-Way D-Tap Splitter (10') and the IndiPRO Tools 15V Power Supply with 4 x Female D-Tap Outputs (8') is two feet of cable.