Add padded protection to the interior of your Nanuk 960 case with this Multilayered Cubed Foam Insert. Simply place the foam pieces in the case, put equipment on top, mark gear outlines, and remove pick-and-pluck cubes as required. The insert consists of a convoluted piece for the lid, a protective base pad on the bottom, and a prescored cubed layer for the middle. When measuring the gear to the case and removing the cubes, make sure to leave two inches around the perimeter to guard against side impact.

For 960 Case    Three-Layer Design    Prescored Removable Cubed Layer    Convoluted Foam Pad for Lid    Protective Base Pad

Related Questions and Answers

Q: 1. i need interior foam for this case

A: Unfortunately, we do not carry the interior foam for this case separately. In order to have foam for this case, you will need to purchase the HPRC 6300 with foam included: http://bhpho.to/1jnJ1D1

Q: 2. hey looking to see if this would fit a atoms sumo 19 se with the accessories ?

A: Yes, the Nanuk 950 Wheeled Hard Case with Cubed Foam (Olive, 51.9L) can fit the Atomos Sumo 19" SE HDR Monitor, Recorder, and Switcher with it's feet mounted to the monitor inside it. There would also be some room left over for the other parts that are included with the monitor.

Q: 3. How big are the pluck squares ?

A: The pluck squares are approximately inch.

Q: 4. There is a foam for the bottom and top of the case. Is only 1 of the other two foam layers scored? If so, how do you buy a single scored layer to replace the bottom full foam layer to increase capacity in the case?

A: Both of the two middle layers will be pre scored for easy plucking. And to purchase just one layer individually, you would have to contact Nanuk for that.

Q: 5. What is the height of the two divider inserts?

A: The height of the divider inserts is 8.5".

Q: 6. Will this case hold the fly more battery kit also ?

A: This is a new product; but while waiting for images the dimensions are 18 x 13 x 6.9" / 45.7 x 33 x 17.5 cm and it has PRE-CUT foam. It's listed as fitting: DJI Avata FPV drone, Goggles, Controller, Battery, Cables and small accessories. Although the battery may have to be IN the drone. Official images coming soon.

Q: 7. Will this case fit a Sony A7Sii?

A: Hi, yes, this case can be used for an A7s II.

Q: 8. Is the foam cubed that I need to cut out or is the foam cutout the way it shows in the picture?

A: The foam is pre-cut into the configuration shown in the images. For the standard cubed foam configuration, please see https://bhpho.to/363A8N4

Q: 9. what is country of origin for this Nanuk 930 case? Thanks.

A: Canada

Q: 10. Can the FOAM be custom shaped / cut to fit a SONY PMW-300K1?

A: Yes, the foam is "scored" like pick and pluck type so you can pull it apart neatly to fit the camera shape and other devices.