The Avenger E250 Long Double Baby Pin 5/8"is 4.9" long and fits into a super clamp or any other locking 5/8" receptor.

Zinc-Plated Steel Construction

Related Questions and Answers

Q: 1. How many pounds can this support?

A: Load Capacity 4.41 lb (2.0 kg)

Q: 2. Why you bought this pin and not the Avenger E650 ?

A: The Avenger E250 Long Double 5/8" Baby Pin is 6.0" long and fits into a super clamp or any other locking 5/8" receptor.

Q: 3. Will this go over a 2" pipe?

A: Yes, this can handle pipes up to 52mm or 2.04".

Q: 4. If I put 5 pounds of vertical pressure on this while attached to a window will it come off the glass surface?

A: The Avenger F1000 Pump Cup with Baby Swivel Pin capable of holding up to 4.4 lb payload.

Q: 5. Are these suitable for the Elinchrom HD500s? Or should I be going for the Avenger E650s instead? Would ideally like the indents to screw into

A: The Avenger E650 https://bhpho.to/2EfFAxQ would be better. The collar will prevent slipping out of a grip head.

Q: 6. How much weight can this hold?

A: The Avenger F820TH Baby Swivel Pin with Ball has a load capacity of 28.7 lbs.

Q: 7. What is the smallest pipe this can fit on?

A: The smallest pipe that the Avenger C338 can fit on would be 20mm or 0.78 inches.

Q: 8. Can I place this on top of c-stand legs to mount lights lower to the ground?

A: This would not be the correct pin. For a turtle base you would want a junior to baby adapter. https://bhpho.to/3kQKMvF

Q: 9. How much weight can this hold? Do you think it can suspend properly a Westcott Zeppelin 47 with the Bowens mounting bracket, the focusing rod, a Bowens speed ring and a Phottix Indra500 TTL?

A: It's not quite as simple an answer as you may like. It depends on how you angle the pivoted extension. If it's angled down a 90 degree angle and a lightbox is simply hung from the spigot, then it should support pretty well any modifier and light. But if you angle a heavy modifier beyond 90 degrees down and therefore have to rely on the friction/clamping of the two small wing nuts, you may find it frustrating, ie. difficult to hold a position. Hand tightening the wing nuts probably won't create enough grip on the spigot and you'd probably have to use a wrench or pliers to add leverage to the tightening. I bought this drop down pin for, as the name implies, it's ability to drop down a light modifier and simply hang it on the spigot. If you keep to that use, or use it with a light weight modifier/light combo which should be ok to angle at other than 90 degrees, then you should be fine. I hope this helps.

Q: 10. Can I remove the pin? is there a 3/8 thread inside?

A: I don't think so. you can get Manfrotto 241FB Pump Cup with Flat Base and add a pin separately BH #MA241FB