[75 ohms] We have 2 of these out ,even after a week of rainy weather these chargers haven't dropped below 90 percent and during deer season we get a ton of pictures!

[3480 mA / 12 V] I have had the Jr2 triggers for a couple weeks now and so far they have been very reliable. I like being able to adjust the power of my remote flash from the transmitter. I use the transmitter in the hotshoe when I am shooting wedding formals and portraits and then I use a PC Sync cable and mount it to the bottom of my camera via the 1/4-20 screw for off camera flash during the reception. I have had Radio Poppers in the past and they too performed well.

[PAL, NTSC] Best of the Best!!! 3D, Upconversion, legasy format playback, control. Hands down it is the BEST VTR in the industry.

[SMA] I purchased a few of these solar panels and I have been impressed. They really last a long time and let the camera maximize the power. A few of my panels have been out for almost 2 years.

[12.6 V] I have a Flex camera located in the pine woods facing north. I tried a Flex-S but there wasn't enough sun to keep it charged. This solar panel is much bigger and can be positioned independent ly of the camera. Now months later the camera batteries are still at 86%.I did brush snow off once, not much snow this winter.

The solar panel has a lot of ports and comes with a lot of cables. Seems excessively complicated but I was able to get it installed in the dark. I am guessing I could use it to charge my phone if necessary.

I don't screw into my trees, I use the included strap. I used the screw bracket to get what I think is a good sun angle. It works using the parts included.

The cable is long enough to reach the opposite side of a large tree. It won't work to position the solar panel at the top of the tree. Realistically, I am not going to the top of the tree to mount a solar panel even if that is where the sunlight is. I might consider mounting the solar panel on a different tree if a longer cable was available but it is working and a longer cable is going to be more likely to be damaged by falling trees or gnawing animals.

It is working well as is. There will be more needles on the trees in the summer but it is big enough I expect it to keep working well.

Unlike a Flex-S, the app doesnt show the battery charge of the SLB-22 internal battery.

[12.6 V] Works great with the JrX series, since those are no longer made.

[5700-5800 MHz] We have had the Spypoint Flex G-36 out since end of November and on July 4th it quit communicating. I was wrong in assuming that having a solar panel attached would keep batteries going. That being said, it has worked great for over 7 months. We now just have to make the 4 hour trip to change out internal batteries and recharge the solar panel. That being said, we have on average at least one picture sent to app every 2 hours when communicating and a couple with every motion. On a busy day we could get upwards of 24+ pictures, so I guess it has worked great for us for over 7 months. Very happy with product.

[10 W] This remote works great. Controls focus an will trigger both the flash an the camera. Or just the camera. You do need the cable to connect it to the camera. They don’t tell you that.

[WFM] I have tried the "Built in Solar" models and sorry but they all seemed to have issues whether it was getting wet inside the camera or just not holding a charge. The SPLB-22 in my opinion is a simple and tested (over a year now) solution. As of today I have had Zero issues with the four I have bought, these have already paid for themselves with what I have saved in buying batteries and not having to take the time to change batteries. If you want a "Set it and Forget it" solution these are worth the money. Charge the panel completely before taking it to the woods, make sure to have adequate expose to the sun, connect to camera and you are good to go!

[10 W] Use for location and studio shoots. Love controlling all my lights from the camera.Love the new improvements over older Jrx line. Like the four channels over just three and the LCD screen over dials. Changing battery from Cr123 to more common AAA batteries is a major improvement. Very simple to set up and use with just about any type of flash.