The Fiberbilt PP8x5 Padded Partition is a divider used to provide additional adjustable space for a Case Design Fiberbilt 10" deep Adapt-A-Case. It is an interlocking divider made from 1/8" Masonite with foam padding.

Adjustable space to fit your equipment

Interlocking, foam-padded partitions

Padded side walls

• Case Design Fiberbilt P20A Adapt-A-Case

Related Questions and Answers

Q: 1. What are the internal measurements?

A: Fiberbilt by Case Design P50 Versatile Mount and Print Shipping Cases 11 x 14", 2.0" Deep has internal dimensions of 11x14x2 inches.

Q: 2. Is this insert the exact same one that is included in the 925 case with padded divider (B&H # NA9252001 MFR # 925-2001)?

A: Yes that is correct. In the photo the set looks slightly different, but it's just the way the dividers are rearranged.

Q: 3. I see the dimensions for the outside pouch, but what are the dimensions for the INNER pocket?

A: The inner pocket measures 5x9".

Q: 4. Is this sturdy enough for checked baggage on a flight?

A: The Fiberbilt by Case Design P508 Adjustable Tripod Case is sturdy enough to be used as checked baggage on a flight.

Q: 5. What colour is the insert? Is it black or gray?

A: These dividers are gray.

Q: 6. When the divider insert is added to the Nanuk 925, how much actual useable space remains? In other words, how much of the internal dimensions of the case are used up by the insert?

A: The whole bottom section of the case is filled, and the egg shell foam fills the top lid completely.

Q: 7. How many mounted competition prints can fit in this (depth-wise)?

A: It really depends on the thickness of the board you are mounting the prints to. The case is three inches deep. So best is to figure out which board you are mounting the prints to and see how many can fit in three inches.An example is 4 ply board on an average is about .0610 thick. If you are not matting the prints but just putting the prints on board, divide .0610 inches in to 3 inches. And that is about 49 prints. But the print has thickness so that is just approximate and only if you use 4 ply board.

Q: 8. Will this fit a Fuji x100t?

A: the 7-15 has a dimension of w 6.0 x h 2 3/4 x d 5 3/4

Q: 9. How big is the exterior pocket? Will it accommodate the Manfrotto 322RC2 grip action ball head? It's about 9 long by 3.5 in diameter at the widest point.

A: The useable pocket space is about 5 3/8 (zipper down to pocket bottom) x 8 3/4 (across inner side seams) - the pocket itself being bit larger. My tripod fits well into the bag but does not allow much give to the pocket depth. Hope this helps. Pleased with quality of the bag.

Q: 10. Has anyone tried to put this in Pelican 1510?

A: The Nanuk 935 is larger than the Pelican 1510 case so the divider sets are not interchangeable. However there are 2 options for dividers for the Pelican 1510 specifically and both cost less than the Nanuk set: https://bhpho.to/3VZW9qo and: https://bhpho.to/35WWKvR