The AKG CK80 is a modular hypercardioid shotgun microphone capsule designed for use with the AKG GN series, HM 1000, and LM 3 gooseneck, hanging and lavalier microphone fixtures. The hypercardioid polar pattern minimizes noise and ambiance at the off-axis (sides) of the microphone. The result increases directivity and provides high gain-before-feedback response when using near speakers or monitors.

The CK80 features pristine detail and accurate reproduction. The dual wind screen design employs an outer layer which disperses initial wind stream while the second layer further diffuses the wind stream before reaching the diaphragm. The module design allows quick and easy capsule replacement for added flexibility.

The CK80 shotgun capsule features a linear 80 degree pick up pattern for an ultra focused pick up at long range.

The CK80 is designed with a threaded connection for use with the GN series, HM 1000 or LM 3 microphone fixtures. The modular design offers quick capsule replacement and enhances flexibility.

Gold platted connector pins achieve better conductivity and provide better overall audio quality.

The dual layer windscreen provides a primary layer which disperses the incoming wind stream while the second layer further diffuses wind flow before reaching the diaphragm.

Related Questions and Answers

Q: 1. Based on the description showing stage use , we bought two of these and put them on the edge of our stage facing the audience in the hopes of a decent ambient pick-up. They are picking up way too much from the rear and the manual actually says that they are either super cardiois or hyper cardioid which would not have as much rear rejection as a plain cardioid. Am I misunderstanding something or can you please advise us on a more appropriate selection? We are a church with a fair amount of stage volume and need these primarily for in-ear ambiance and the results were practically no vocals and little audience with mostly stage music from drums and guitar amps.Thank you

A: There are adapters in the box. One has holes to skew the response curve to voice. There is another to reject background sound. I think it comes with it installed. Did you check your db settings? It has a switch to drop the output.

Q: 2. Does it require phantom power?

A: Yes. The Audio-Technica AT4053b Hypercardioid Condenser Microphone BH #AUAT4053B requires 48V phantom power.

Q: 3. what about the Shure FP System. Does it work? the lav from the kit is too big.

A: It will work if you use a readily available TA 3 to TA 4 adapter.

Q: 4. Hi. Is this BluTooth enabled?

A: No, this microphone plugs into a wireless microphone transmitter with a 3-Pin Miniature XLR input. If you have a BluTooth transmitter that has an input for a microphone with a 3-Pin Miniature XLR, it would probably work.

Q: 5. On off switch?

A: The Synco Mic-D1 Hypercardioid Shotgun Microphone does not feature an on-board "On/Off" switch. The switch found on the Synco Mic-D1 Hypercardioid Shotgun Microphone is a "High Pass Filter" switch which filters out low end frequencies below 180Hz.

Q: 6. I need a hypercardioid mic for interior dialogue recording on a boom pole. Is it possible the this mic can deliver in such a task? Or is it too heavy. Too bulky? Thanks.

A: I use this mic in our studio on a C-stand and hand held for street interviews. I do have some shoots coming up in August where I am going to purchase a boom for it. It's definitely bulkier than a choir mic, but I love the sound (don't forget to put the hypercardioid adapter on it that comes in the box).Hope that helps,Jeff

Q: 7. How is the noise compared to a boom mic?

A: A mic like the AT4053b would be recommended for indoor dialog capture. The pickup pattern is wider than a traditional shotgun, however for indoor were there are many reflective surfaces, this is a benefit as compared to a more directional mic.

Q: 8. Does it require battery power or phantom power or it works without any power supply?

A: It requires phantom power.

Q: 9. What all comes in the package for this specific microphone?

A: The AKG CM311A/SH is outfitted with a TA4f connection compatible with Shure wireless systems. Along with the microphone, you also get a carrying case, a WS-6 foam pop filter and one clothing clip.

Q: 10. Will this capsule fit/work with an AKG C460B preamp section?

A: This capsule is only compatible with AKG GN series and LM3 housings.