The computer monitor arm mountwill allow you to affix your monitor to your 0.2 to 2.2" thick desktop or countertop by a clamp-on mount with a number of adjustment options. It provides 22" of extension from the mount, plus 12.6" of height, -90 to 45° of tilt, 180° swivel, and 360° roll adjustments. The mount will support displays up to 29" and 17.8 lb.

Supports Displays up to 29"    Supports Displays up to 17.8 lb    For Desk or Counter Tops 0.2 to 2.2"    Clamp-on Mounting Base    Provides 12.6" of Height Adjustment    Provides 22" Extension    Provides -90 to 45° Tilt Adjustment    Provides 180° Swivel Adjustment    Provides 360° Roll Adjustment    TAA Compliant

Articulating arm allows monitor to be adjusted to your preferred position to help reduce eye, back, and neck strain.

Ease of motion provided by bushings at all pivot points.

Compatible with VESA 75 x 75 and 100 x 100mm

Monitor can be positioned anywhere from 0.25 to 18.5" above the desktop surface measured at the center of the adapter.

Integrated cable management will help keep cables looking neat.

Related Questions and Answers

Q: 1. What is the L x D of the item? The only measurement I read is the Height of 3.25"

A: The dimensions of the Mount-It! MI-7263 Traditional Glass Computer Monitor Stand are 22" L x 8.25" D x 3.25" H.

Q: 2. How much clearance is necessary for the bottom screw mounts that hold the monitor to your 'desk?' I am currently using a 6ft folding table and have 1.5 over-hang. Thanks.

A: I'm not sure what you're asking, a picture might help. I have about 9 between botthom of my screws & top of desk

Q: 3. could it be used with an eizo cs 2740 monitor?

A: Yes the Mount-It! Rolling Computer Workstation with Monitor Mount has a VESA mount pattern that is compatible with an CS 2740.

Q: 4. My printer is 23"WX18.36"DX15.1H and weights 44lbs. I want to put it in the bottom shelf. Specs say that the width is 23.5 but that's from wheel to wheel. What are the dimensions of the bottom shelf? Thanks.

A: The bottom shelf is of the Mount-It! Rolling Computer Workstation is 18.5" x 14".

Q: 5. I have a 27 , 19.4lbs. monitor attach to this stand. No matter how much I tighten the retaining bolt, the monitor always sags downwards. How can I keep my monitor held upright with this system? Thanks.

A: I have the same exact issue with my 24 inch monitor that is attached to the right side. Left side is perfect but ride side sags down ever so slightly. I have accepted it as is. Very weird.

Q: 6. Will this work for only two monitors? I have two 24 16:10 LCDs and would like to know if I can put them side by side while I wait to get the third monitor. I would attach them to the outer mounts if they arms bend enough to push them together.

A: You could try but you will need an extra weight for support on the base as it will be a bit unstable.

Q: 7. Does it come with the screws (should be 12 of them)?

A: Yes is comes with the 12 screws needed do mounting the monitors.

Q: 8. Are the screws for securing monitor to arms included?

A: Yes - everything is included

Q: 9. Can you stack them?

A: Yes, but the bottom shelf can only support up to 44 lbs.

Q: 10. will the arms go low enough for the bottom of 24 monitors to touch the desktop?

A: Yes. The extensions have enough articulation for most 24 monitors to touch the desktop.