Adding color to a specific region of your image, the 5 cup filter coffee machinefrom 5 cup filter coffee machineproduces a warm, pinkish coloration to isolated portions of the frame with neutral results maintained in the opposite half of the image. This filter's coloring is densest at one edge and tapers to clear by the middle, with a hard-edged transition between the color and clear areas. This filter is ideally suited for adding color to an otherwise plain scene or to emphasize and complement existing tones in your image.

This filter is constructed from optically correct resin, measures 150 x 170mm, and is compatible with the LEE SW150 filter holder.

Graduated Color Filter    Selective Coloring to a Portion of Image    Resin Construction    Compatible with LEE SW150 Holder

This 14 density filter offers the most coloration compared to the range of other available densities.

Produces a colored portion of an image while retaining a neutral portion for creatively enhancing the look of scenes.

Constructed from optical resin for maintained image quality and clarity.

Filter measures 150 x 170mm, is 2mm-thick, and is compatible with the LEE SW150 filter holder.

Related Questions and Answers

Q: 1. Can I use on wet surfaces? For example, pool side or bottom of pool?

A: Suction cups work best on a dry surface. If the surface is too wet the suction cup wont hold at all.

Q: 2. Will this fit the new Sony A7 iv?

A: Yes, the Sony FDA-EP19 Eyepiece Cup works with the Sony A7 IV.

Q: 3. How easily are you able to remove the mount after use/change its location on the vehicle?

A: I have the GoPro suction mount. It is very simple to attach, remove, relocate. Position the mount and camera where you want it. Press the center of the mount firmly into the windshield, then flip down the lock lever, done! To remove, lift up the lock lever, then with your finger tips, peel up the edge of the suction cup. This will cause it to release from the windshield. Mount works great. TIP: get an assortment of GoPro mount adaptors and extensions for different mounting situations you will inevitably encounter. Good luck...

Q: 4. What size is the screw? Is it removable so I can replace it with a longer screw?

A: The screw size is 1/4"-20 and not adjustable.

Q: 5. Is this compatible with the new Hero 12?

A: Yes, the GoPro Suction Cup Mount is compatible with the GoPro Hero 12.

Q: 6. Does this fit the sony a7c?

A: No, the following eye cup is for Sony Alpha a77III

Q: 7. Can multiple GorillaPod arms be attached in series to obtain a longer reach?

A: With an adapter you can join two or more together, such asManfrotto 120DF Female 3/8 to Female 3/8 Adapter Plate B&H # MA120DF MFR # 120DF

Q: 8. Anyone have experience with attaching this to a hub cap on a car?

A: The wheel cover must be flat and/or smooth. Then the cap and the suction cup must be immaculately clean and dry. If they are not, the mount will not stay on. This is good only for moderate speeds.

Q: 9. What are the internal dimensions?

A: The interior dimensions of the PortaBrace Padded Lens Cup (7") are 3.5" x 4" x 7.25" / 8.89 x 10.16 x 18.42 cm.

Q: 10. If I have it in the outside of a car going 70 mph is it strong enough?

A: Yes it is: Mount Proven at Speeds of 150+ mph Maximum holding strength requires attachment to a clean surface