Mount an off-camera flash, LED light, or monitor to a tripod, stand, or bar with the Manfrotto 244 Micro Friction Arm. The arm features one 1/4"-20 threaded stud and one 3/8"-16 stud; one can be fitted to a clamp or mounting device, while the other side can be used for holding various types of gear or accessories. This arm helps you to place accessories like gobos and scrims in difficult-to-reach positions. It will support up to 6.6 lb and can be easily installed using the hex key.

Length: 5.9"    Two 3/8" Studs    One 1/4"-20 Adapter    One 3/8"-16 Anti-Rotation Adapter    Includes Manfrotto Nano Clamp    Clamping Size 0.5-1.37"    Load Capacity: 6.6 lb

Related Questions and Answers

Q: 1. My printer is 23"WX18.36"DX15.1H and weights 44lbs. I want to put it in the bottom shelf. Specs say that the width is 23.5 but that's from wheel to wheel. What are the dimensions of the bottom shelf? Thanks.

A: The bottom shelf is of the Mount-It! Rolling Computer Workstation is 18.5" x 14".

Q: 2. I am building a custom desk and want to know how much clearance I should leave in the back in order to use this mount. Would two inches be enough? I Plan to have a crossbar run along the back of the desk but I want to have it be far enough into the desk for this to fit

A: I agree with Dany D. below, 3/4 is enough, 1 to be safe.

Q: 3. Can you adjust each arm for each monitor to a different height independently on the pole (to accommodate 2 monitors of different sizes)?

A: Yes you can.

Q: 4. Are the screws for securing monitor to arms included?

A: Yes - everything is included

Q: 5. How much clearance is necessary for the bottom screw mounts that hold the monitor to your 'desk?' I am currently using a 6ft folding table and have 1.5 over-hang. Thanks.

A: I'm not sure what you're asking, a picture might help. I have about 9 between botthom of my screws & top of desk

Q: 6. Can the two outside arms be turned around so the monitors are placed in a 360 degree fashion? For a triangular table set-up.

A: Yes: This full-motion desk mount features 15 degree monitor tilt and 180 degree swivel capability at multiple points for fine-tuning monitor positioning. Number of Displays Supported 3, Side-by-Side

Q: 7. What is the L x D of the item? The only measurement I read is the Height of 3.25"

A: The dimensions of the Mount-It! MI-7263 Traditional Glass Computer Monitor Stand are 22" L x 8.25" D x 3.25" H.

Q: 8. what is the minimum height of the 15.75" x 27.5 work surface? What is the minimum height of the upper shelf?

A: The lower height is 37.25" and the max height is 53.75" for the Mount-It! Rolling Computer Workstation with Monitor Mount upper work surface.

Q: 9. Will this work for only two monitors? I have two 24 16:10 LCDs and would like to know if I can put them side by side while I wait to get the third monitor. I would attach them to the outer mounts if they arms bend enough to push them together.

A: You could try but you will need an extra weight for support on the base as it will be a bit unstable.

Q: 10. could it be used with an eizo cs 2740 monitor?

A: Yes the Mount-It! Rolling Computer Workstation with Monitor Mount has a VESA mount pattern that is compatible with an CS 2740.