2 Channel Stereo Receiver With Subwoofer Output

Product Code: eq27458
Availability: In Stock

$987.00 $1,460.76

Qty

16 reviews Write a review

Description
Reviews (16)

The Listen Technologies Intelligent DSP IR Receiver is for use with the company's infrared assisted listening systems. The unit features two 3.5mm stereo output jacks that can drive two pairs of headphones or a single LA-430 lanyard for T-coil users (both available separately). The result is a convenient listening experience in small-to-medium places where it's difficult to hear—including theaters, boardrooms, classrooms, courtrooms, houses of worship, and more.

The receiver has an OLED display that shows unique channel names, battery status, channel status, volume status, and charge activation. The micro-USB connection is used with the free iDSP software suite for set up, programming, inventory management, firmware updates, and charging via any standard USB port. A field-replaceable, lithium-ion battery is included with the unit that powers it for up to 8 hours.

Audio
Frequency Response	63 Hz to 15 kHz (±3 dB)
Signal to Noise Ratio	Mono: >60 dB Stereo: >52 dB
Distortion	<2% Total Harmonic Distortion (THD) at 80% Deviation
Audio Output Jacks	2 x 1/8" / 3.5 mm Female, Unbalanced Nominal Output Level: 0 dBu Maximum Output Power: 16 mW Impedance: 32 Ohms Accepts Mono or Stereo Phone Plug
Controls
User Controls	Power On/Off and Volume Up/Down
Set-Up	Press and Hold Up/Down Volume Buttons for 5 Seconds to Enter Channel Adjust, Use Up/Down to Select Channel
Programming	Via Software and USB Port
Indicators
LED	Flashes when Batteries Are Low/Charging, Solid when Fully Charged
Display	OLED Shows: Channel Designation, Battery Level, Unit Number, Charging Status, Volume Status
RF Specification
Carrier Frequency	2.3 MHz, 2.8 MHz, 3.3 MHz, and 3.8 MHz
Number of Channels	4 x Selectable Channels
Frequency Accuracy	±.005% Stability (32 to 122°F / 0 to 50°C)
Modulation	FM Wideband, ±50 kHz Deviation Max, 50 uS De-Emphasis
Specifications
Sensitivity	IR: Better than 1 nW/cm2 @ 40 dB SNR
Squelch	IR: Programmable in 20 Steps, Automatic on Loss of IR Signal
Power Save Mode	IR: Turns Unit Off After a Specified Time of No IR Signal, Default Is 30 Minutes
Power
Battery Type	Lithium-Ion
Battery Life	8 Hours of Typical Use
Battery Charging Time	2.5 Hours
Power Supply	Micro-USB Connector, 5 V, 500 mA
Environmental
Operating Temperature	14 to 104°F / -10 to 40°C
Storage Temperature	-4 to 122°F / -20 to 50°C
Humidity (Non-condensing)	0 to 95% Relative Humidity
Compliance and Approvals
Standards	FCC Part 15, ICS-03, CE, RoHS, WEEE
Physical
Color	Flat Black
Dimensions	Unit: 3.75 x 2 x 0.64" / 9.6 x 5 x 1.7 cm Unit with Belt Clip: 3.75 x 2 x 0.80" / 9.6 x 5 x 2.1 cm
Weight	Unit: 1.9 oz / 53.9 g Unit with Batteries: 2.8 oz / 79.4 g
Packaging Info
Package Weight	0.22 lb
Box Dimensions (LxWxH)	4.3 x 2.3 x 1.3"

High-sensitivity infrared receiver for assisted listening systems

Use with LA-430 neck loop/lanyard (available separately) with DSP loop driver to improve the listening experience for T-coil users

OLED display shows unique channel names, battery status, channel status, volume status, and charge activation

Can be worn around the neck, with the included belt clip, or concealed in a pocket

Use for single-channel applications

Related Questions and Answers

Q: 1. Will this work with the RodeLink wireless system? I want use with my Tascam DR60D

A: To connect the RodeLink receiver unit to a recorder via XLR we recommend the Rode VXLR adapter that can be used with the included 3.5mm cable supplied with the RodeLink system. Due to differences in output and wiring we do not recommend this cable for the RodeLink system.

Q: 2. Can you connect a TV and 5.1 surround sound speakers to this

A: This is a stereo receiver, which means it is for two speakers. A TV can be connected, but only through analog stereo RCA connections. I would recommend an A/V receiver, such as the Sony STR-DH590 5.2-Channel A/V Receiver, BH #SOSTRDH590. This receiver will allow you to hook up to your TV with an HDMI cable, and accepts 5 speakers, as well as a powered sub woofer, for a 5.1 surround sound system. .

Q: 3. Will this work with Sennheiser ew100 g3 wireless receiver?

A: Yes, this will work with a Sennheiser ek100 receiver.

Q: 4. Is the pass thru full range or does it out put only the levels above what you set for the sub?

A: The Rolls SX95 Stereo Subwoofer Crossover / Filter features a true pass thru output that will allow proper connection to your system without any alterations to the original signal.

Q: 5. Will the Rca output support a sound bar?

A: Yes it will.

Q: 6. Is it good for the JBL 4312A (8 ohms) speaker?

A: The vintage JBL 4312A are control monitors and designed for in studio use. They could be connected to the STR-DH190 Stereo Receiver but will not sound as good as they should. They sound best with more power than this AV home receiver can muster!

Q: 7. Will it support a sound bar through the Rca output?

A: Yes it will.

Q: 8. Is there a way to adjust the balance between right and left channels? I don't see it on the unit or remote.

A: Hi Doug, Yes there is. You have to enter the Amp Menu. Use the up and down arrow buttons in the middle of control to navigate. Scroll until you see "BAL" in the display. Then adjust accordingly. Hope this helps.

Q: 9. Are the inputs and outputs line level or speaker/high level?

A: Line Level

Q: 10. Do you need a phono preamp to plug in a ken wood turntable?

A: No. This receiver offers a Stereo Phono Input.

Cip_007	29/09/2024
[0.22 lb] Hi! I just both cd 60 along with stereo 70s. Nice match for both design and quality sound. But still I have a question that I am trying to answear mysel... is DAC in cd 60 better then what stereo 70s has in it? What DAC should I use between those two for best sound. What model are they... these info is nowhere to be found. Should I use rca or optical? If optical then I belive I use stereo 70s (amp dac) 5

John	13/09/2024
[Flat Black] They work great and did what was needed. 5

Jordi	12/09/2024
[2.5 Hours] Great quality. Solid build and it's fully black. 5

anyonymous	06/09/2024
[Lithium-Ion] Beautiful design and functionality amazing sound quality that can’t be matched, I love it!!! 5

Joseph	05/09/2024
[Flat Black] Excellent sound reproduction. At 75 watts per channel it works great with my JBL speakers. Sounds great at low levels. I recommend this unit for it’s traditional function as a wonderful stereo receiver. 5

Hill1	28/07/2024
[0.22 lb] This Stereo 70S is so nice to look at, as are all the new Cinema styled Marantz pieces. It is in my kitchen, and as can be seen, is paired with Definitive Technology D7 bookshelf speakers (amazing gems.) Suffice to say this is a wonderful piece of audio/video jewelry, it is so gorgeous looking, and the sound is clean, very musical, and I would say accurate to the source. My wife uses this system and she loves it! HEOS connects with it perfectly, and I am so happy she is enjoying great sounding music! The fact that you can have 2 pair of speakers with this unit, either playing separately or together, is a really nice feature that I know will be used eventually. The new remotes are so nice and solid feeling as well, and the knobs on the front turn with the heft and feel of products costing much more. If you are looking for an easy to use/set up amplifier with excellent streaming capabilities, this should be at the top of your list.Thank you Marantz! 5

Joseph	13/07/2024
[Flat Black] I am very pleased with this amp, purchased to replace on old Bose Stereo Lifestyle system. The HEOS system took only minutes to set up, enabling me to stream internet radio, Sirius, and Spotify. I use it only for stereo music reproduction including CD. The sound is great. I have no regrets and would recommend it. 5

Ura Prd	24/06/2024
[Lithium-Ion] I tried other XLR connectors which didn't work but with this cable I was able to succesfully work with my mic and sony camera. 5

Gary	23/05/2024
[Lithium-Ion] these cables are better than the CL100 sennheiser cable I have purchased both these seem way better quality 5

Derek	15/05/2024
[Flat Black] I love that it works just the same and sounds just as good. I think I like the construction more than the original. The binding around the cord at the base seems stronger than the other which was the problem with the other wearing out. Glad I bought this, and cheaper than original too! 5