Mix And Go Personal Blender

Product Code: eq29740
Availability: In Stock

$15,597.00 $18,872.37

Qty

8 reviews Write a review

Description
Reviews (8)

The mix and go personal blenderfrom mix and go personal blendergives performing and recording musicians simple, intuitive control over their monitor mixes, allowing them to dial in the perfect mix themselves, without having to tell an engineer to change the mix for them.

Offering three-band master tone controls optimized for in-ear monitors, and the ability to monitor 16 mono or stereo sources with per-channel volume and stereo placement, the A320 gives musicians powerful control over their mix, while also preserving the simplicity required for use while performing.

The A320 also provides the musician a way to maintain specific mix settings consistently, night after night, and show after show. The unit includes space for eight mix presets, so you can save the perfect mixes for each tune, and recall them at will, to ensure reliable results in your monitors every time.

Parameters
Audio Output	1/4" TRS stereo, headphone or line level
Output Connector	Tip: Audio Left Ring: Audio Right Sleeve: Ground
Network	A-Net I/O: 1x A-Net In, RJ45 connector; supports Pro16 and Pro16e Pro16e A-Net: Use Cat-5e (or better) cable, maximum 400 ft (122 m) between devices, supports power Over A-Net Cat-5 Cable: Use shielded Cat-5e (or better) cable to stay below the CISPR 22 Class B, ICES-003, and FCC 47 CFR Part 15 Class B emissions limits
D/A Conversion	44.1 / 48 kHz, 24-bit
Stereo Linking	Stereo Link, per channel pair; Set at the input module; Variable pan per mono channel or pan/spread per stereo channel pair
Headphone Output	275 mW per side into 50 ohms (both sides driven)
Output Impedance	5 ohm
Frequency Response	3 Hz - 22 kHz +0.2 dB/-3 dB at 50 Ohms
THD + N	< 0.003%
Output Voltage	24 VDC, 0.5 amp; transmitted over Cat-5e cable
Signal to Noise Ratio	-106 dB (measured with zero data into all channels)
Latency	0.880 msec (measured from analog input to analog output)
Power	24 VDC, 0.5 amp; Power is supplied over the Cat-5 cable when connected to an Aviom A-Net Distributor
Dimensions	10.26 x 6.14 x 1.91" (260.60 x 155.95 x 48.51 mm)
Weight	1.3 lb (0.59 kg)
Packaging Info
Package Weight	2.015 lb
Box Dimensions (LxWxH)	14.65 x 9.1 x 5.5"

Whether you're adding to an existing Aviom personal mixing system or building a new one, getting up and running with the A320 is designed to be a breeze. For older systems, the A320 runs in Pro16 mode, with 16 channels spread across the interface and stereo sources occupying adjacent channel buttons, like on the popular A-16II Personal Mixer. For systems with more channels, the A320 switches into Pro16e mode, utilizing the full power of its 32-channel mix engine to support any combination of 16 mono or stereo sources

Related Questions and Answers

Q: 1. Does it come with a copy of Studio One Artist?

A: No just the faderport, I used with Logic Pro and Protools and work perfect

Q: 2. Can this be used as a control surface for audio in Blackmagic ATEM software?

A: Yes, the PreSonus Faderport 16 Mix Production Controller should be capable of controlling basic audio parameters in ATEM software using the Mackie Control Universal emulation protocol.

Q: 3. Is there a something that can be attached to hold a laptop?

A: There is no specific laptop holder designed for the GLORIOUS Modular Mix Station; however, we do offer some laptop stands that can be positioned on the center of the desk such as the Ultimate Support LPT-1000QR HyperStation QR 5/8" Thread-Mountable Laptop / DJ Stand with QuickRelease Center Post (Black), B&H # ULLPT1000QRB.

Q: 4. Could this fit an m32r?

A: Midas M32R mixer; Dimensions: 478 x 617 x 208 mm (18.8 x 24.3 x 8.2") Gator G-MIX Specs: Exterior Dimensions: 24.5 x 21.5 x 9.5" (62.23 x 54.61 x 24.13cm) (LxWxH) Interior Dimensions Rackable space: 21 x 19.25 x 6.5" (53.34 x 48.9 x 16.51cm) (LxWxH)

Q: 5. Do you place the wedge foam on the lid or underneath the mixboard? Also, the velcro seems to be weaker than the weight of my mixboard, anyone else have problems with the mixer flopping around and pushing past the velcro wedges?

A: The foam goes under the mixer. To the best of my knowledge I havent heard of any issues with the Velcro moving around. You might want to get a few pieces of foam and fill any space around the mixer so it wont move .

Q: 6. When will this item be available for purchase? If I can know specific date, I will be able to pre order. Thanks.

A: We do our best to keep our site update with the latest information available to us. At this time Expected availability: Mid October 2016. You can choose to be notified by email when this item becomes available by clicking on the Notify When in Stock icon on the product page.

Q: 7. Will this controller work with Premiere Pro 2022?

A: Yes you can use the PreSonus Faderport 16 with Adobe Premiere Pro or Adobe Audition.

Q: 8. Will it fit Midas M32R mixer which is slightly higher? 24x19x8.4

A: Unfortunately it will not, however at NAMM 2017 we just released a brand new large format mixer bag, the G-MIXERBAG-2621, which will provide a perfect fit for the M32R. It will be available in Spring 2017. Further information here: a href= http://www.gatorcases.com/p/210122-2600/g-mixerbag-2621 target= _blank http://www.gatorcases.com/p/210122-2600/g-mixerbag-2621./a

Q: 9. I would like to know if I can operate with it on a Protools 12.5 running on a Yosemite osx?

A: Yes, the PreSonus Faderport 8 is compatible for use with Pro Tools 12.5 and Mac OSX Yosemite.

Q: 10. Will this controller work with StudioLive 32R and how to connect to UC Surface?

A: The Presonus Faderport 16 Mix Production Controller is only a DAW controller, and it is not compatible with UC Surface.

David	29/08/2024
[< 0.003%] For my needs as an audio engineer, which are primarily post-production workflows, this board is tremendous. From my research, nothing else in this price point even touches this thing in terms of functionality and reliability. I'm on Pro Tools so I'm using it in it's more stripped-down HUI mode, but even then it's working seamlessly and helping me make mixes SO much faster. 5

BWE	25/08/2024
[2.015 lb] Well made case. Rugged construction that should hold up to years of my abuse. 5

Michael	24/08/2024
[2.015 lb] Ive been wanting to get a production controller for a long time but just could bring myself to spend the money. Prior to this unit the only other unit I was looking at is made by AVID. I really like this one. Its solid and feels nice. Works great with Pro Tools, Premiere Pro, and Audition for Mac. 5

Anthony	19/08/2024
[5 ohm] Finally got the clouds to look like clouds while the rest of the scenery wasn't underexposed...! 5

Nitu	14/08/2024
[2.015 lb] Works well with my Lumix camera for video shooting. It's much better than a standard ND filter since this filter will darken skies and bring out the detail in clouds. 5

Iain	07/06/2024
[< 0.003%] It's getting hard to find sefour storage at a reasonable price, and this solution fit my purpose and provided me an opportunity to organize my setup a little more. I'm very happy with the quality, and I took time to build it, and not rush. Overall I'm extremely happy. Price point was fair for the solution I have. 5