Combine microphone and stereo line-level audio sources neatly with the black Whirlwind MIP3 One-Gang Passive Wall Plate Audio Mixer. Its RCA and 1/8" inputs have an attenuation pot for blending line input levels with the microphone input. It also passes phantom power from the output terminals to the mic input, enabling the use of both dynamic and condenser microphones.

Single-Gang Design    XLR, Stereo RCA, 1/8" Inputs    Screw Terminal Outputs    Ground Lift Switch

• Combines a microphone with a stereo line level audio source into a single mic-level output

• Works with both dynamic and condenser microphones and passes phantom power from your sound system to the mic input

• The ground lift switch breaks the ground connection between the inputs and the output screw terminal

Related Questions and Answers

Q: 1. Is this compatible with Dante?

A: The SoundTools WallCAT WC851 Analog Audio Over Cat5 Wall Plate (White), BH #SOWC851W, is not Dante compatible. It will easily send or receive four channels of XLR, AES3, DMX or intercom over Ethernet cabling to multiple locations.

Q: 2. it's 4k support?

A: Yes - if high-speed HDMI cables that support 4K are utilized.

Q: 3. I have three Shure Cardioid Boundary Condenser Mics and would like to mix them into one line which will be plugged into a computer's mic-in. Will this mixer work for my needs?

A: The Sescom 3-Input, 1-Output Passive XLR Mixer will mix and sum the signal of three microphones as desired, but because it is passive, will not supply phantom power to condenser microphones.

Q: 4. is the connection with USB type B (1.0) compatible with 2.0,2.1? compatiable with USB type C using adaptor?

A: Yes. You can connect the included cable to a USB -C port, using an adapter like this: https://bhpho.to/2ZVqVWw

Q: 5. Can the Whirlwind PressBox6 be fed by the LMPRE mic preamp to make an inexpensive mult box?

A: Yes, that set-up should work fine.

Q: 6. This unit is rev2 or rev3?

A: Rev 3

Q: 7. Can this do a stereo mix out? And if so, can it feed the stereo mix to an iPhone? Or an iPad?

A: Yes, you can create a stereo mix using the Roland GO:MIXER Pro-X which can output to an iPhone or iPad.

Q: 8. Can this be used to mix multiple headphone outputs into one headphone output or is this only intended for line in/out?

A: Although the Rolls MX41B could technically be used for headphone signals, the impedance of its inputs & outputs is not the same as the typical impedance range of headphones. This may lead to undesirable results and lower audio quality.

Q: 9. connecting sound from computer through POD DI to go through sound system?

A: You need an audio mixer with XLR inputs to use this PodDI, but yes, this is used to output audio from your laptop or music player through your PA.

Q: 10. 1) Can this simultaneously output to both USB and TRRS? 2) Can it be powered by USB and output to TRRS? (No battery operation)

A: 1) Yes, you can output through both USB and TRRS at the same time on the Roland GO:MIXER PRO-X Audio Mixer for Smartphones. 2) Yes, the Roland GO:MIXER PRO-X Audio Mixer for Smartphones takes USB power or battery power and can output through TRRS at the same time.