Finish your installation with a clean look with the stainless steel Whirlwind WP2/4QW 2-Gang Wall Plate. It features a two-gang design with four Whirlwind WCQF 1/4" terminals to pass your wiring through the wall, reducing the appearance of cable clutter.

4x Whirlwind WCQF 1/4" Terminals    2-Gang Design

Related Questions and Answers

Q: 1. What diameter are the screw holes, and how far apart are the holes from each other?

A: According to the manufacturer you can use 6d or 8d nails, or drywall screws. They do not have a measurement for the spacing.

Q: 2. Which hole is the "safety cable hole"?

A: safety cable goes on the Baby Pin

Q: 3. How big are the holes and what' the spacing? Was thinking of putting some magnets on this and want to get some ideas on sizes

A: The larger holes are 5mm, and the smaller 3mm. From center to center the large holes are 5.5 cm apart. From center to center the small holes are 3.5 cm apart. The entire plate is approximately 7.5cm x 14.5cm

Q: 4. What is the dimension from the back of the plate to the far end of the receiver?

A: It is about 3 inches from the back of this plate to the far end of the receiver.

Q: 5. Is this compatible with the Matthews BabySitt'r?

A: This is a Baby 5/8 pin it's compatible with any Baby pin accessory.

Q: 6. What are dimensions of the flat plate itself (not the receiver)?

A: The size of the plate is approximately 5.9x3.6".

Q: 7. Is the pin removable?

A: The pin is welded in place.

Q: 8. What is the distance between the bigger holes on the short end?

A: From the center of each hole, we measured 65mm with a vernier caliper.

Q: 9. Will this fit a matthews BabySitt'r?

A: No, the base plate of the Matthews Junior Wall Plate is too large to fit into the Matthews BabySitt'r.

Q: 10. Can the handle be removed?

A: Yes the handle can be unscrewed.