[Max 24 V] Only way the DJI RS3 communicates with my Nikon Z6ii is by USB so I really can only start and stop recording with RS3. Obviously needed to have this capability with hands remaining on gimbal. Works great!

[0.5 lb] Thats the review, LOL. Don't mess with the RedRock Micro motors unless you like to have endless problems. The next cheapest option for the Movi Pro with use on the Movi controller is the Chrosziel. Most pros use the Heden's but this works just fine, plug it in and set to Chrosziel in Movi controller FIZ setup and boom ready to go.

[27.6" / 700 mm] This is a great tool to use focus on my Zhiyun Crane 2 gimbal. I ordered two more because the original one I've had for years started to struggle to connect with the microUSB port. I could have been more gentle with the microUSB connection and also it got plenty of use! If you do purchase this, I recommend updating the servo follow focus firmware on it, for AB point compatibility, and using the original Zhiyun USB cable when doing that update. (The cable that comes with the Crane 2). For some reason these older Zhiyun products don't like off brand cables. I'm not sure what's different about the Zhiyun cables but they work.

[0.5 lb] Haven’t used it a ton yet. But compared it to the Teradek motor, and the Heden MV26 (paired with a It’s definiteky quieter and smaller - and about half the weight of the Teradek, which was already pretty light. I dig the ingenious rod clamp that adapts to either 15 or 19mm internally without the need for an adapter that you could lose. I am using it with my Chrosziel Magnum 200. Has no problem pulling stiffer cinema lenses. The only potential negative is that the cable that runs to the receiver is fixed. So while that reduces weight with the reduced connector, if the cable gets damaged, your motor is out of commission until the motor cable is repaired (taking the whole motor out of use). I intend on having a backup motor. Given that Chrosziels system is compatible with other brands of motors (unlike the Teradek), should be easy to find one to swap in.

[27.6" / 700 mm] Small and very lightweight. Easy to calibrate, but sometimes have to remove battery to re-calibrate. The thin controller that goes with is brilliant.
And on/off switch would help. It’s tricky to figure out to push the battery to the side.

[Max 0.5 Nm] Great handle. Perfect for low mode flat steadicsm plates on arriflex cameras and alike.

[0.5 lb] Paired this with my All in one combo made all the difference in the world.

[0.5 lb] even though I thought that the pricing is a little on the expensive side I am pleasantly surprised with my new Chrosziel shoulder support for my FX6. I am able to mount the camera in three different positions, the shoulder pad is easy to adjust, comfy and easy to slide back and forth. looks like you can also add a rear rod support which I haven't purchased yet but will def get it

[Max 0.5 Nm] Works Perfect! It is my First follow focus and it is very simply to use. Very good service and contact with sellers. Fo every questions i have fast feedback. Magnum its automatic calibrate and fast. He has a several options preset. It is also good work with hard cinema lenses and ring for lens. I recommend this product to professional work. In our TV also use this systems.

[Max 0.5 Nm] SO FREAKIN TINY AND LIGHT. Dont let the size and weight fool you though, these motors pack some punch. Works with many different lenses and so easy to balance longer setups. Must have.