Rolls Ilc19 In-Line Level Control | Compact Audio Solution

Rolls Ilc19 In-line Level Control | Compact Audio Solution

Product Code: eq32626
Availability: In Stock

$207.00 $293.94

Qty

17 reviews Write a review

Description
Reviews (17)

The Rolls ILC19 In-Line Level Control | Compact Audio Solutionfrom Rolls ILC19 In-Line Level Control | Compact Audio Solutionis a line-level control for XLR balanced signals. It features a female input jack on the front and a male output jack on the rear with a rotary level-control knob on the front panel. It can also be used in reverse, meaning that the rear male jack can be the input, with the front female jack being the output. The ILC19 is compatible with a mic- or line-level balanced signal.

For Mic- or Line-Level Balanced Signals Level Control for Balanced XLR Signals Balanced XLR Input and Output Small Compact Size

General
In-Line Accessory Type	Attenuator/Pad
Controls	1x Output Level/Volume Knob
Connectivity
Inputs/Outputs	1x XLR 3-Pin Female Input 1x XLR 3-Pin Male Output
Performance
Impedance	Input: 5 Kilohms (Balanced) Output: 5 Kilohms (Balanced)
Max Input Level	+30 dB
Max Output Level	+30 dB
Physical
Dimensions	2.25 x 2.25 x 1.55" / 5.7 x 5.7 x 3.94 cm
Weight	0.35 lb / 0.16 kg
Packaging Info
Package Weight	0.45 lb
Box Dimensions (LxWxH)	7.9 x 4.6 x 2.2"

Related Questions and Answers

Q: 1. Is the (RCA) monitor out a passthrough from the RCA inputs?

A: Yes, the Sescom SES-ON-THE-LEVEL's monitor output is a direct passthrough from its inputs.

Q: 2. Does this cable work for zoom f6 too??

A: Hi Ching. This cable attenuates the signal 35dB, so it might attenuate the signal a bit more than desired. We have a couple of cables specifically for the Zoom H6, the LN2MIC-ZOOMH6 and LN2MIC-ZMH6-MON. These Zoom H6-specific cables attenuate 25dB rather than 35dB. The LN2MIC-TASDR100 cable will work, but you might have to raise the audio level up on your camera if the audio level is a bit low. Thank you!

Q: 3. How many channels of audio does the cable send?

A: This, Sescom LN2MIC-TASDR100 Line Out to Camera Mic Level In Cable, is intended to pass stereo (L/R) signals.

Q: 4. Is this amp bridgeable for mono?

A: The MA255 does not support bridged mono operation.

Q: 5. As far as I can tell, there is no master volume for the headphone output. There are only individual controls for mic, instrument/line, and monitor/mix inputs. Is that correct?

A: That is correct - the ART MyMonitorII Personal Monitoring Solution Mic/Line Mixer does not have a single, dedicated master volume control for its headphone output. Instead, the MyMonitorII offers four dedicated level adjustments (Mic, Inst/Line, Stereo Monitor Left, Stereo Monitor Right) which allow the user to create a custom blend of the inputs used on the mixer and which all contribute to the headphone output level, which can achieve a maximum output of +12dBu.

Q: 6. Does this cable work for Panasonic Lumix S1R and Zoom H6? Thank you!

A: Hi Edward. For the Zoom H6 recorder, we recommend the LN2MIC-ZOOMH6 or LN2MIC-ZMH6-MON assembly. Thank you!

Q: 7. Is this cable ideal for connecting a mirrorless camera such as a GH4 -- with its dedicated mic input -- to a recorder such as the Tascam DR-60dmkII -- with its dedicated camera outputs -- or will any standard 3.5mm stereo mini cable do? I want to achieve the cleanest possible signal between camera and recorder. Any advice or recommendation is appreciated.

A: The Tascam DR-60dmkII features a dedicated camera mic level output. Any standard 3.5mm cable will suffice to get clean audio from the recorder to the camera.

Q: 8. Does this work with a Bluetooth adapter line in signal?

A: Yes you can go from the line output of the Rolls DU30b into a bluetooth transmitter.

Q: 9. Is the "direct out" before or after any trim/gain adjustment? Looking to boost 8 mic signals to 8 line level. Will this do it?

A: The direct output on the Rolls RM82 8-Channel Mic/Line Mixer is taken immediately after the preamp stage, before any signal processing or adjustments.

Q: 10. Is the output signal truly FULLY balanced, i.e. is there both a (+) and out-of-phase (-) signal?

A: Yes, the outputs are fully balanced

Stephen L	23/09/2024
[Attenuator/Pad] WOW, with this little box you will be surprised, it has transformed my home theater 100 percent. My front mains LCR speakers have taken on new life, RCA pre-outs to XLR inputs on power amp now matched. No more ground loop noise, clean and clear audio sound with lots of dynamic range which I could not get with out it. I have two of them. JUST GREAT. And by the way B&H service is great also, Thank You. 5

Brian Cho	15/09/2024
[+30 dB] I use the LM2U 2-channel line level converter to convert the sound from the balance to computer sound card use. It's very good as expected. 5

Matthew	14/08/2024
[0.45 lb] I'm using an AVR as a pre-amp to an external amp that has balanced inputs. The AVR only has unbalanced outputs, so I bought the LM2B to convert the AVR signal to balanced. The advantage in doing this is that the balanced signal is about 6db stronger than unbalanced, giving me lots of headroom, and the amp doesn't have to work as hard to get the volume I need. I did a lot of research on these converters, and the LM2B seems to have the strongest performance specs of all the ones I looked at. So far it works and sounds fantastic. Great solution for converting unbalanced signals in a home theater set up. 5

Martin	02/08/2024
[+30 dB] This unit performed as described. However, I needed one that had a much shorter delay so I returned it and promptly got a refund. 5

cswroe	29/07/2024
[Attenuator/Pad] I buy these fairly often for several different applications. They are tremendously reliable and allow low voltage control. 5

Fredsing	17/07/2024
[+30 dB] I'm a one-man band with a small CD player (for background tracks), and Roland AC60 amp. I use the line out feature from the cd player to the aux input of the amp. I had no way to EQ the music, which sometimes has too many highs, and vise versa. The Mx153 gives me the EQ capability I need to soften or brighten up the music as needed. Thanks Rolls, and Thanks B&H for the great service and low price. 5

Hypno	16/07/2024
[Attenuator/Pad] I have several of these mixers. They are the primary component for my sound system. I have 2 wireless mics and a PC for music running through the mixer. I am a stage performer and love the simplicity and reliability of the Rolls MX153. I just put another system together with a Bose L1 Compact and it is rock-solid. If you need a small and simple mixer, this is the one! 5

anyonymous	21/06/2024
[0.45 lb] The ACRs we use are needed to prevent noise from being injected into the paging systems output when not needed. They control the proper output from our security voice output when it is needed. They work really well for that need. Can not think of anything bad about the units. 5

Eric	04/06/2024
[Attenuator/Pad] This item is a good device for if you to splice audio signals that have to have a common output. i am using this for a customer of mine in a sports bar for hooking up a jukebox and internet radio to a common mixer channel. For something of this nature its good for that. I understand you can use these in multiples but for what Im using it for it does the job!! 5