Mount an accessory onto your rig with the GyroVu Accessory Mount 1/4"-20 Thread 15mm Rod Clampfrom GyroVu. The durable aluminum mount features a single, standard 15mm rod clamp and a 1/4"-20 mounting thread. It secures on a separately available 15mm rod using a locking lever and can support an accessory that weighs up to 3 lb.

1/4"-20 Mounting Thread    Single 15mm Rod Clamp    Locking Lever, 3 lb Load Capacity    Durable Aluminum Construction

Related Questions and Answers

Q: 1. how is this twist-free? I don't see any pins at the bottom

A: The Kondor Blue 15mm Rod Clamp to Accessory Mount (Space Gray) has a twist free Arri connection. The attached accessory is what has the pins not the clamp.

Q: 2. How much weight can this support?

A: I use mine to connect to a counterweight for balance on a camera rig -- around five pounds. The clamp seems fairly sturdy and could probably handle even more weight (within reason).

Q: 3. What size are the mounting screws? I am assuming 1/4"-20 to screw into a smallrig cage for example?

A: The threads of the two mounting screws included with the SmallRig Single 15mm Rod Clamp (B&H# SM1549) are 1/4" in diameter with a thread pitch of 20. Yes, that makes them 1/4"-20 screws.

Q: 4. What is the weight capacity? Can it handle a magic arm with an Atomos 7" Ninja Inferno and two np-f750 batteries?

A: Niceyrig does not list a weight capacity however I would not recommend using this for a Ninja Inferno. The weight of that monitor with batteries on it may cause the clamp to slip. This product is best suited for smaller lighter weight products such as video transmitters, and microphone receivers.

Q: 5. Can you remove the screw that holds the thumbscrew, leaving another threaded 1/4"-20 hole on the clamp, or is the screw permanently attached to the clamp?

A: The thumbscrew is required to tighten the rod clamp on the 15mm rod. In addition to that the screw for holding the thumbscrew is smaller than a 1/4 20

Q: 6. Can I remove the locating pin?

A: No. locking pin is fixed in its place.

Q: 7. Can I use this to mount a Kondor Blue d-tap hub splitter onto a 15mm rod?

A: No, the Kondor Blue 15mm Rod Clamp to Accessory Mount (Space Gray) would not connect to the Kondor Blue Male D-Tap to 4-Port Female D-Tap Splitter Hub. One solution would be a Magic Arm. BH #KOKBMGCARMBK and replacing one of the ends with a 15mm BH #KOB15BALL. Many customers also work with this NATO clamp to attach it to a NATO Rail on their cage or rig. Kondor Blue Anti-Twist NATO Clamp (Space Gray) BH #KOKBNATOCAT. You could also work with the following Wooden Camera Universal 15mm Rod Clamp (1/4"-20) BH #WOA00131

Q: 8. Is it possible to change to orientation of the locating pins?

A: Hi Mark. You can take a small flat head screwdriver, remove the pins and move them to another threaded hole.

Q: 9. Does the M4 screw fit into the 1/4-20 screw holes?

A: An M4 Screw and a 1/4"-20 threading are not compatible.

Q: 10. Would this work to add a single rod onto a cage?

A: Yes it can do that.