This unit has a wide range of applications for access control and security system accessories that require additional power.

• Filtered and electronically regulated output
• Short circuit and thermal overload protection
• Built-in charger for sealed lead acid or gel type batteries
• Automatic switch over to stand-by battery when AC fails
• AC fail supervision
• Low battery supervision
• AC input and DC output LED indicators

Related Questions and Answers

Q: 1. What is the difference between this SKU, INPRFPS, and IN15V4DT?

A: The difference between the IndiPRO Tools 15V, 10A AC Power Supply to 4-Way D-Tap Splitter (10') and the IndiPRO Tools 15V Power Supply with 4 x Female D-Tap Outputs (8') is two feet of cable.

Q: 2. Will this adapter replace the MG-18200S that I can't find anywhere?

A: I believe that this is a viable replacement power supply.

Q: 3. When using this with the Sennheiser DC 2 - DC Camera Power Converter, how do you tell or know that are the negative(-) and positive (+) when soldering?

A: I put a multi meter to be absolutely sure of the polarity. But anyway you will find that the wire that is black with lettering from the power supply will get soldiered to the black with white stripe wire on the fake battery pack. The black with a white strip will be your positive. Your solid black wire will be your negative on both.

Q: 4. Is it 10' from the brick to d-tap? Or 10' total?

A: The total length of the IndiPro Tools 15V, 10A AC Power Supply to 4-Way D-Tap Splitter (10'), measures at 10'.

Q: 5. Does this power supply work with the ARRI Alexa LF?

A: Yes, the ARRI Power Supply Light 24V will work with the ARRI Alexa LF. The ARRI Power Supply Light 24V connects to camera cables for the ARRI Alexa LF's BAT port.

Q: 6. What camera cable do I need to connect this to the Arri Alexa LF?

A: Power supplies are connected with a cable (for example KC-20 or KC-29) to the ALEXA LF BAT connector. We recommend using the ARRI Power Supply Light 24V (K2.0034493) or the Power Supply NG 12/26 R (K2.47351.0) to power the ALEXA LF. However, the Power Supply NG 12/26 R is not available for sale anymore, due to discontinued parts of the supplier. Please note, that the AMIRA and ALEXA Power Supply Light (K2.0006876) is not suitable to power the ALEXA LF. While it works fine in low power demanding situations, it may not work in high power demanding settings. Do not use this power supply with the ALEXA LF.

Q: 7. work with lorex cameras?

A: This power supply works with most analog cameras that require 12v dc power.

Q: 8. How is this powered may I ask please? Does this convert a mic terminated with a 4 pin to work with XLR? Will I need to phantom power afterwards?

A: The device requires 48V phantom power on the XLR side. I'm using it with a Zoom H4n, with phantom power enabled. I asked this same question to the audio-technical people, and they said that you need to send phantom power to the microphone through the AT8539 and that can come from either a recording device such as a mixer (the H4n, in my case) or an external phantom power supply, such as the AT8801. Hope this helps.

Q: 9. Is the TVS-h874 supported?

A: The QNAP 350W Power Supply Unit BH #QNPWPS350WFS is not listed for the TVS-h874.

Q: 10. Do these power supplies come with a plug-in AC cord? Rhe spec says 3 wire input with strain relief?

A: No. They are designed to be connected directly to the breaker panel.