The Kramer Dual RJ-45 Wall Plate Insert, in gray, is a single-slot insert with two RJ-45 connectors supporting Cat 6 cabling. One way of using it is with the optional RK-WP6 19" rack adapter.

Single-Slot Wall Plate Insert

Permanent Link/Channel of TIA/EIA-568-B.2 Cat 6, ISO/IEC 11801, Cenelec EN 50173, IEC 60603-7, PoEP in accordance with IEEE 802.3

Related Questions and Answers

Q: 1. Does this have to be used with a Marshal PTZ controller? Could I use this with the PTZOptics SuperJoy to control cameras?

A: This is a universal solution from Marshall. It works best with their controllers. However, It should also work with other controller brands.

Q: 2. Can I connect my DSLR camera to my computer for live-streaming purposes using this cable?

A: You will need to connect your camera to a video capture card, and then connect that to the computer in order for your camera to be recognized as a webcam and use it for livestreaming.

Q: 3. Will this work with a Ubiquity Dream Machine Pro?

A: Yes, this AVPro Edge 1.25G SFP to RJ45 Module, 1000Base-T Ethernet Transceiver (up to 328') is compatible with the Ubiquity Dream Machine Pro but they do not recommend third party. https://help.ui.com/hc/en-us/articles/212561258-UniFi-USW-Which-SFP-Modules-Can-be-Used

Q: 4. Will this fit into a Domke F-6 (Little Bit Smaller) bag? The published dimensions of this are just a bit bigger than the bag's published internal size.

A: No, too big.

Q: 5. Would this insert fit Sony A7II, A7rII, A7sII?

A: I can't answer his question because I am not familiar with his product. I use the insert for lenses and small binoculars

Q: 6. Does the CAT cable that runs between cameras use the standard 568B wiring or does it need to be a crossover cable?

A: Standard wire is more than fine.

Q: 7. What size mud ring would be used?

A: The picture shown is the old style. They actually changed the design to a 1G wall plate! Uses a standard Carlon low voltage 1 gang box or old work frame (orange color). See Kramer's site for new design. Same part number.

Q: 8. do this adapter fit a Does standard USB port and does the opposite end accepts a standard phone plug?

A: This network adapter is not a standard USB its USB-C.

Q: 9. Can i use this accesorie to connect a Marshall Electronics VS-PTC-200 to a switch and control 3 ptz ip cameras?

A: The Marshall Electronics CV620-CABLE-06 would not allow you to do this but if your camera models are compatible with this cable you could daisy chain from one camera to the other for control. Marshall Electronics CV620-CABLE-07 8-Pin RS-232 to RJ-45 Adapter Cable BH #MACV620CAB07 • MFR #CV620-CABLE-07 If your cameras are IP based we recommend IP controllers like the following. Marshall Electronics PTZ Camera IP/NDI Controller BH #MAVSPTC300

Q: 10. Will this insert add any rigidity to the F2 bag? My F2 is a little too "floppy".

A: From personal experience, the dividers add very little to the rigidity of the bag, but make it very lightweight and easy to travel with. There is adequate protection for most cameras and lenses as long as I am not too rough with my gear. Going along with some of the other answers to this question, the underneath/external side of the Domke dividers have pockets where the foam is inserted. You might want to consider adding firmer/more rigid material (such as cardboard) on top of the foam just to add even more rigidity.