Store, protect, and transport your camera gear with the black SKB iSeries Zippered Divider Set Black Think Tank Designfrom SKB. This divider set may be used alone or as an insert for SKB iSeries 2011-7 or 2011-8 cases. It features a 7" deep, fitted, zippered, removable interior with a closed-cell foam liner and touch-fastening dividers wrapped in Nylex. To help you organize equipment, the set comes with seven regular dividers and four 90°-bend dividers. Carry the set with the adjustable, removable shoulder strap or the nylon strap handles. The high-contrast gray interior lining makes it easier to locate gear in low light.

Fits SKB iSeries 2011-7 or 2011-8 Cases    Zipper Closure    Closed-Cell Foam Liner    7x Touch-Fastening Foam Dividers    4x 90°-Bend Touch-Fastening Dividers    Adjustable, Removable Shoulder Strap    Nylon Strap Handles    High-Contrast Gray Interior Lining

Related Questions and Answers

Q: 1. will this fit in the pelican 1535 Air case?

A: Measure the insert and then the interior of your case. That is the answer to your question.

Q: 2. Will this fit the Airport International V2.0?

A: Yes SKB iSeries 1610-10 Think Tank Designed Divider Set will fit but it is much smaller, you would need to use double stick velcro purchased separately to keep it from moving around.

Q: 3. Does this come with egg-crate foam for the lid?

A: Hi Rich, No it does not. Thank you,Will

Q: 4. Is this insert compatible with the Pelican 1510?

A: No, this insert is too long to fit in the 1510.

Q: 5. Will this fit a Pelican 1510 cherry one case?

A: I have a pelican 1510 case and this divider. The fit isn't perfect but it works. On the pelican case where the wheels raise into the interior of the case the divider does not fit well. It causes the divider to lift and buckle slightly but does not interfere with lid or seal. My gear is still well protected and feel this was a good purchase.

Q: 6. 18.5 x 13 x 5.5" are the dimensions of this insert. If I put pressure onto the top, would the 5.5 inches reduce to 5 inches? I would be inserting this into a check-in luggage which has a 5 inch wall height.

A: I do feel you would be fine with compressing about half an inch yes. Though I am not sure I would check luggage with camera gear unless it was intended for airline travel for camera gear like the SKB and Pelican cases are.

Q: 7. Will this fit well inside the Pelican 1510?

A: The Pelican 1510 dimensions are: 19.8 x 11.0 x 7.6 in (50.2 x 27.9 x 19.3 cm), while the SKB iSeries divider's dimensions are: 20.4 x 11.4 x 5.0 in (51.8 x 29.1 x 12.7 cm). As it is larger than the Pelican's internal dimensions it would not fit properly.

Q: 8. Dimensions 22 x 17 x 6 inches ..... Could this insert with a height of 6 inches fit into a box 5.5 inches tall?

A: Being that this iSeries 2217-8 Divider Set is slightly taller, it may not allow the box to close all way.

Q: 9. How thick (padded) is the bottom of the divider? Same as the sides and interior dividers?

A: According to SKB, the thickness of the base is 0.5” inches (12.7 mm) and the cell wall thickness is 0.125” inches (3.175 mm).

Q: 10. What is the weight of this item?

A: The SKB iSeries 1711-6 Think Tank Designed Divider Set weighs approximately 0.75 lbs.