The 15.7" FREEFLY MōVI Pro Lens Motor Cable 15.7"from FREEFLY MōVI Pro Lens Motor Cable 15.7"is used to connect a lens control motor on your MōVI Pro rig. This cable features an ultra-thin, flexible design for easier routing and dressing on your rig.

The 7-pin LEMO connector on one end of this cable plugs into your lens motor and the Molex Micro-Fit connector on the other end fits into your MōVI Controller or Pilot. See below for a list of compatible lens moto

For MōVI Pro Gimbal Stabilizer    For Select Lens Control Motors    Thin, Flexible Cable for Easier Routing    15.7" Long Cable

Including but not limited to:

Model: M21VE-L/M26VE with 256 encoder, 3.3k ID-resistor

Requires Mōvi firmware v1.1 or later

Model: Reflex

Requires Mōvi firmware v1.3 or later

Torque Motors

Requires Mōvi firmware v1.3.2 or later

Related Questions and Answers

Q: 1. Is this cable for use with non-EF lenses?

A: This is meant for separate motors mounted on 15mm or 19mm rails. It cannot be used directly with EF lenses.

Q: 2. Which batteries does it use? Are they different than the M10/M15?

A: Yes, they are different batteries. The old ones are not compatible.

Q: 3. Does it come with the 4 screws for the Alexa Mini?

A: This is for the Movi Pro gimbal and does not include screws.

Q: 4. Does the Movi Pro ring collapse for travel?

A: The MōVI Ring can't collapse, but you can remove the handlebar. It's about 22.5 inches without the handlebar or 26 inches with the handlebar.

Q: 5. Does this work with the MDR.X

A: No, The Teradek 3-Pin to 3-Pin R/S Power Cable for MDR.S Receiver does not work with the MDR.X.

Q: 6. Does this work with the Tilta Power Passthrough Plate Kit for DJI RS 4?

A: Yes, the Tilta D-Tap to 2-Pin LEMO Power Cable (15.7”) has a two-pin LEMO connection that would work with the Tilta Power Pass through Plate Kit for DJI RS gimbals.

Q: 7. does this kit include the mimic unit as well?

A: Yes it does, the Mimic is included in this kit.

Q: 8. how much do the weigh?

A: According to Chrosziel the CDM-100M (including gear, cable and clamp) weighs only 0.29 lbs.

Q: 9. Will this plug directly into the Movi Pro and receive power and control from it. I'm assuming you can control from the Mimic?

A: According to FREEFLY, the support for the Chrosziel motor is coming soon.

Q: 10. How is this different from the original ring?

A: the original MOVI Pro ring can only mount the gimbal in the upright configuration. the MOVI Pro Ring II can mount the gimbal in the upright or underslung position.