The Da-Lite 93043LRVN Motorized Screen 87x116" 120Vfrom Da-Lite 93043LRVN Motorized Screen 87x116" 120Vsupports ceiling or wall mounting. Tensioned screens ensure the smoothest surface possible.

150" Diagonal / 4:3 Aspect Ratio    High Contrast Cinema Perf Surface    1.1 Gain / 100° Viewing Angle    Smooth Roll Technology    Tensioning Cable System    SCB-100 RS-232 Control    Specify Veneer When Ordering    Low Voltage Control (LVC)

High Contrast Cinema Perf is a perforated vinyl surface that allows for the installation of speakers behind the surface. It features a gray base for deeper reproductions of black, which improves contrast, and an increased reflectivity to enhance brightness where a moderate level of ambient light is present. Cone: 100° Gain: 1.1

• Standard Low Voltage Control (LVC) to keep your screen operation flexible
• Smooth Roll Technology to keep your screen flat
• Slim-Tab, a lower profile, stronger tab design to keep your screen taut
• Tensioning Cable System to prevent warping and ensure even lateral tension
• Black-backed screen material for enhanced image quality and opacity
• Seamless screen surface

An added circuit board that allows for opening or closing the screen with a relay switch or RS-232 protocol communication.

This screen can be ordered with any of the Da-Lite veneer options. Please specify which option you would like when ordering

Allows the included wall switch, as well as devices such as automation systems, third-party wall switches, and remotes that support LVC, to raise or lower the screen remotely.

Related Questions and Answers

Q: 1. Is the Impact ELH lamp used in the Kodak 860H Carousel projector?

A: Yes you can use the ELH 300 w lamp or an ENH 250 w lamp

Q: 2. Can i use this bulb for Lowel Light DP? my house outlet is around 240v

A: yeah I bought the same one and used it for DP too (I shot a movie in Israel which is 220V

Q: 3. Will this bulb work in a “vintage” Kodak Carousel 750?

A: Yes this lamp would be compatible with your projector.

Q: 4. Does this bulb works for an old LOWEL TOTA LIGTH??

A: Yes.

Q: 5. will this bulb work with the mole richardson mickey mole?

A: Yes, the ARRI DXW Lamp (1000W/120V) works in the Mole-Richardson Mickey-Mole 1K Focusing Flood Light (120-240 VAC).

Q: 6. can it be layed on its side or does it have to stand up like in the photo ?

A: Yes, it can be laid on its side. Be sure any venting holes aren't blocked. Also, it's just a battery backup and doesn't have a liquid battery that you'd have to be concerned with spilling, so you should be fine.

Q: 7. What bulb is suited for a Kodak Ektagraphic IIIE SLIDE PROJECTOR?

A: any bulb designated ELH 300w

Q: 8. Will this 600w 120v bulb work with the Arri 650w fresnel light? Or just the Arri 600w open face light?

A: The Impact DYS Lamp (600W, 120V) will NOT work with with the ARRI 650W Plus Tungsten Fresnel (120-240 VAC) the correct lamp is a Osram FRK (650W/120V) Lamp

Q: 9. Does this bulb work w an Arri 300W Plus?

A: Yes, the Sylvania FKW Lamp would work on the Arri 300 Fresnel.

Q: 10. Does this work with the Profoto D2's?

A: Yes, the d2 is end-user replaceable and will adapt to the following Ushio DRA Lamp (300W/120V) bulb system.