Designed for large venues, the 120V Da-Lite 29254G Wireline Advantage Motorized Projection Screen 120Vuses thin steel cables instead of black drop to lower the screen to an appropriate viewing height. Once the screen is installed, the screen's trim conceals the rough opening in your ceiling, eliminating the need to complete additional trim work. Sliding installation brackets help make it easy to attach the screen housing to the structure above the drop ceiling.

226" Diagonal / 16:10 Aspect Ratio    HD Progressive 0.9 Surface    0.9 Gain / 170° Viewing Angle    Suspended from Cable up to 29'    Slim-Tab, Low-Profile Tab-Tensioning    Hand-Held Remote Included    Built-In Radio-Frequency Motor    Seamless, Black-Backed Screen Surface    Flangeless Case

Ideal for moderate to high output projectors, the light gray surface provides balance between color reproduction and image contrast. Cone: 170° Gain: 0.9

• Up to 29' of cable to accommodate appropriate viewing height in rooms with high ceilings
• Slim-Tab, a lower profile and stronger tab design to keep your screen taut
• Tensioning Cable System to prevent warping and ensure even lateral tension
• UL Plenum-rated case
• Works with separately available radio-frequency control accessories such as a single-channel wall switch, dry contact interface, and RS-232 interface
• Black-backed screen material for enhanced image quality and opacity
• Seamless screen surface

Case does not have trim flange, making it suitable for non-ceiling-recessed applications.

Related Questions and Answers

Q: 1. Will this work if the base is e27 ?

A: This bulb is a universal E26 / E27 Edison screw base which fits most monolight strobes and fixtures that accept the standard Edison base.

Q: 2. Does this lamp have a 5.5 inch width?

A: From end to end it is 6.6 (167mm) long.

Q: 3. I have Lowel Tota continuous light. A bulb just got broken in transit.I want this 1000 w instead of 750 w can I use this 1000 w bulb ?

A: No

Q: 4. Can these work with my lowel omni lights?

A: I am not sure since my lights are not Lowel Omni. They are Britek Brifocus.

Q: 5. What bulb is needed for a Kodak Ektagraphic IIIE slide projector?

A: I would recommend the FHS bulb. Click on the link below to view; https://bhpho.to/2V6MttQ

Q: 6. Is this lamp safety coated?

A: No, the Impact JDD Lamp (150W, 120V, 3-Pack) are not safety coated bulbs.

Q: 7. does this fit on the GVM 60w cube light?

A: The GVM 36° Projection Kit was not designed to be used on the GVM 60W light. There is a compatibility list offered by GVM, and it states that this kit will only be compatible with GVM's PR150D, Pro SD200B, Pro SD300B, SD80D, SD300D, SD300S, SD200D, and SD200S models.

Q: 8. How many units of this reference are per box?

A: I'm not sure I really understand...There is one bulb per box. So each bulb/lamp costs $45.82

Q: 9. Is the color produced by the bulb white or orange ?

A: The color temperature of the EMD lamp is 3200k, which means that it is tungsten-balanced rather than daylight-balanced.

Q: 10. Are these incandescent or halogen bulbs?

A: There is a Halogen lamp inside