Created to block light from the camera's lens to avoid flare, the Kupo Flex Arm French Flag Holderfrom Kupo Flex Arm French Flag Holderis a highly bendable 17.5" length of metal with 3/8"-16 female threads at each end, one attached to a camera connector and the other to a flag connector. The arm can support up to 0.66 lb.

Length: 17.5"    0.66 lb Load Capacity    Camera and Flag Connectors    Arm Has 2 Female 3/8"-16 Threads

Related Questions and Answers

Q: 1. Can anyone that owns the kit confirm whether or not you can fit an additional 18"x24" flag in the case (like a solid)?

A: It will be tight but you can fit another 18x24 flag into the Kupo Open-End Flag Kit (18 x 24").

Q: 2. Is this compatible with the Manfrotto Super Clamp?

A: Yes, this arm can work with a Manfrotto Super Clamp.

Q: 3. Will these work with the quasar T8 lamps? or is this only for T12?

A: No; the diameter of a T12 lamp is 1 1/2 inches while the T8 bulbs are only one inch across.

Q: 4. Is the baby pin welded on top? I want to find a stronger handheld boom than the Sunswatter "Heavy Duty" boom, over time the baby pin loosens up.

A: According to the manufacturer, the 5/8" baby pin stud on the end of the Kupo Baby Handheld Boom Arm (Aluminum) is tight fitted into the tube and fixed with crossed pins instead of a single pin. Basically, the baby pin would not loosen if you stay below the maximum payload listing of 7.94 lb (3.6 kg).

Q: 5. Will this connect to Kupo's 3-way clamp?

A: yes

Q: 6. Can you mount this to a light stand or mic stand? If so, how?

A: The Super Knuckle Universal Tablet Holder can be mounted to any light stand that has a 5/8 stud. this will not mount to music stands

Q: 7. Will the this hold the 2’ Quasar Q-Led Crossfade lamps?

A: It should be able to.

Q: 8. Will this grip arm support work with other C-stands with grip arms, i.e. A Matthews Hollywood C-Stand?

A: It can work with any C-stand but you will also need a Kupo 3 way clamp, this fits the C-stand. The grip arm can't be greater than 16mm (I had to look that up on the Kupo site). I bought this when I tried to mount a Westcott Apollo Orb, and pair of Cactus RF60 Flashes with battery packs and it was able to keep it in position. Without it I couldn't keep it upright.

Q: 9. Is the grip handle (knuckle) fixed in position at the end of the rod (arm) or can it slide along the arm and be tightened in any position?

A: Fixed position, you get a 2nd grip head to slide the arm up & down

Q: 10. Will this work on a Kupo (silver) junior riser column (lower/main tube)?

A: It's made to fit Made to Fit 35mm Diameter Columns/Pipe, it will usually fit the top section of the column which should be 35mm.