The Juice Goose JG 8LED Power Distribution for 19" Rackfrom Juice Goose JG 8LED Power Distribution for 19" Rackis intended for use in 19-inch rackmount environments. It features 8 NEMA 5-15R outlets on the back of the unit. All the outlets are rotated 90 degrees to better accommodate "wall wart" power supplies. The outlets draw power via the unit's 6-foot NEMA 5-15P power cord. To protect your installation from electrical damage, the JG 8LED features a back-mounted circuit breaker, line conditioning, and spike protection.

8 AC Outlets    15A Rating    Back-Panel Circuit Breaker    Surge Protection    LED Rack Lighting    6' Power Cord

The JG 8LED provides 8 AC receptacles on the back of the unit. The receptacles are rotated to better accommodate "wall wart" power supplies. Each of the AC outlets is NEMA 5-15R, rated for 15A.

The JG 8LED has a 15A circuit breaker and a 12A maximum current rating.

The unit features AC power protection that includes a fast-acting metal oxide varistor, which guards against high-energy surges between the line and neutral power leads. This protection also includes filtration capacitance, which enhances the surge protection and adds a primary level of line-noise elimination.

The power cord is rated for 15A and features a NEMA 5-15P plug. It's 6' long.

The JG 8LED features a circuit breaker mounted on the rear of the chassis and is rated for 15A.

The JG 8LED has two slide-out light tubes that provide dimmable LED rack lighting.

LED lighting is designed to be long lasting and should never need replacing. It also can be left on for extended periods without creating significant heat.

Related Questions and Answers

Q: 1. what are the dimensions?

A: The dimensions of the Adam Hall AH-87404 19" Rack Drawer - 4 U Steel are as follows: Outside height - 4 U Outside width - 434 mm Outside depth - 392 mm Inside height - 175 mm Inside width - 401 mm Internal depth - 373 mm

Q: 2. I need the 12 foot width. But I also have to squeeze into an 8 foot maximum room. What is the minimum witdh when set in place?

A: The crossbar is broken down into 4 sections, which measure 38.2" each.

Q: 3. What is the maximum size of square tubing this clamp will accept. 1X1 inch? 1.25 X 1.25 inch?

A: These clamps accept a thickness of 1 x 1 inches.

Q: 4. Is there a higher version of the rack stand?

A: This is the tallest rack of this type we have.

Q: 5. Does this PDU display per outlet power usage?

A: No, the APC AP7900B Switched Rack Power Distribution Unit only shows the total draw of the device.

Q: 6. Hello, and thank you in advance for your responses. What is the maximum width of the stand when fully assembled and setup for use? Richard Martinez, Houston, Texas.

A: The kit comes with 4 cross bars. Connected together the maximum width is 12 feet wide.

Q: 7. What's the total depth of the legs? (How deep of a table does it need to sit on)

A: The Hosa RMT-254 19 Table-Top rack is 14 inches deep.

Q: 8. Are the screws included with TP-Link Rackmount Kit-19?

A: Yes, mounting screws are included with the TP-Link 19" Switch 2-Piece Rack Mount Kit.

Q: 9. Can a Anton Bauer Mount be switched with the V Lock?

A: You can swap out the rear battery mount plate with an Anton Bauer plate. It will require soldering of the plate leads onto the board however.

Q: 10. Why was this removed from RED's list of Approved Accessories?

A: A reason has not been relayed why RED has removed the Tilta Advanced Power Distribution Module for RED KOMODO (Black) from the RED list of approved accessories.