Tannoy 4" Ceiling Loudspeaker With Dual Concentric Driver

Product Code: eq46422
Availability: In Stock

$1,194.00 $1,468.62

Qty

7 reviews Write a review

Description
Reviews (7)

This pair of Tannoy 4" Ceiling Loudspeaker with Dual Concentric Driverfrom Tannoy includes two full-bandwidth, high-power handling, and high-sensitivity loudspeakers built around Tannoy's CMS 3.0 Ceiling Monitor System technology. Based on a Dual Concentric point-source driver, the speaker delivers wide and consistent broadband directivity, intelligibility, and an accurate and linear response.

The Dual Concentric driver design features Omnimagnet technology and the Torus Ogive Waveguide device, together providing consistent and controlled directivity along with improved high-frequency response. Time alignment and coherence between low and high frequencies enhances performance both on- and off-axis. The baffle provides a subtle extension to the wave-guide effect for additional sonic benefits.

The loudspeaker can be entirely angled towards the listener within the fixed ceiling-mounting ring by pivoting it towards the desired area of coverage. It utilizes a 16-Ohm driver, making it ideal for use in high-performance, low-impedance systems. A low insertion-loss 30W transformer is included, with convenient front switching for taps at 30W, 15W, and 7.5W, with an additional 3.75W tap for traditional constant voltage systems.

Each speaker is supplied with an integral back can, ready to install as a single unit. The removable locking connector has screw terminals for secure wire termination and loop-thru facility. Strain relief is provided by a clamping mechanism for use with a plenum-rated cable or conduit, while the spring-loaded and self-aligning clamps make for quick and easy installation. Each loudspeaker is supplied with a grille, two tile support rails, and a C-ring.

110 Hz - 50 kHz Frequency at -3 dB Omnimagnet Technology Torus Ogive Waveguide Device 16-Ohm Driver 90° Coverage Angle

Parameters
Driver	4" / 100 mm Dual Concentric Omnimagnet driver
Low Frequency Driver	1.38" / 35 mm voice coil, treated multi-fiber paper pulp cone
High Frequency Driver	0.79" / 20 mm PEI dome
Frequency Response	110 Hz to 50 kHz at -3 dB
Frequency Range	80 Hz to 54 kHz at -10 dB
System Sensitivity	88 dB (1 W = 4 V for 16 Ohms)
Nominal Coverage Angle	90°
Power Handling	Average: 60 W Program: 120 W Peak: 240 W
Recommended Amplifier Power	120 W @ 16 Ohms
Nominal Impedance	16 Ohms
Maximum SPL	Average: 106 dB Peak: 112 dB
Transformer Taps	70 V: 30 W (165 Ohms) / 15 W (330 Ohms) / 7.5 W (660 Ohms) / 3.75 W (1320 Ohms) / OFF & low impedance operation 100 V: 30 W (330 Ohms) / 15 W (660 Ohms) / 7.5 W (1320 Ohms) / OFF & low impedance operation
Enclosure	Back Can: Reflex loaded UL 94V-0 rated ABS Baffle: Reflex loaded UL 94V-0 rated ABS Grille: Steel, with weather resistant coating
Safety Features	Safety ring located at rear of enclosure for load bearing safety bond
Clamping Characteristics	Clamping Range: 0 - 0.79" / 0 - 2 cm Recommended Clamp Torque: 1.5 Nm
Mount	Blind mount complete with fixed back-can
Connectors	Removable locking screw terminals with "loop thru"
Compliance	UL-1480, UL-2043, CE
Dimensions	Bezel Diameter: 8.1" / 20.1 cm Front of Ceiling to Rear of Pod: 5.81" / 14.8 cm Hole Cutout Diameter: 7.36" / 18.7 cm
Weight	6.06 lb / 2.75 kg
Packaging Info
Package Weight	18.165 lb
Box Dimensions (LxWxH)	24 x 13.1 x 12.1"

Dual Concentric driver design utilizing Omnimagnet technology

Torus Ogive Waveguide device for broadband directivity

High power and high sensitivity with extended frequency response and very low distortion

Improved LF performance for applications where genuine bottom end is a must

Convenient front tapping switch for settings

Adjustable tilt angle with 360° rotation to accommodate difficult loudspeaker placements

Three-clamp, self-aligning mounting system

UV resistant baffle and grille

Suitable for voice alarm systems, multi-zone foreground music & paging systems, boardrooms & offices, business music systems, airports, convention centers, hotels, reception/waiting rooms, houses of worship, retail outlets, shopping malls, lounges, bars, cruise ships, and courtrooms

Related Questions and Answers

Q: 1. Is it compatible with Tele Vue-76?

A: The Tele Vue Focusmaster Driver 10:1 will work with the Tele Vue-76 newer version, black pinion 10:1 focus. And will not with the older scopes.

Q: 2. If I install 6 of these speakers in a restaurant, which amplifier will go best with it?

A: We have a lot of compatible models. The JBL CSA 180Z Audio Amplifier would be ideal. https://www.bhphotovideo.com/c/product/1070952-REG/jbl_csa180z_1x80w_amplifier_funnels_70_100v.html

Q: 3. Is this compatible with NP101is?

A: Yes, the Tele Vue Focusmaster Driver 10:1 is compatible with the Tele Vue-NP101is 4"/101mm Refractor Telescope.

Q: 4. Do you have a floor stand adaptor to use these as mains with regular speaker stands?

A: The Tannoy VXP 12 does not have a pole mount, but it can be modified to work with a pole-mount speaker stand, by attaching the VTH accessory: https://bhpho.to/42N8GOP

Q: 5. Does this speaker have a 1.375 mounting hole for a tripod mount?

A: The JBL JRX225 Dual 15" Two-Way Sound-Reinforcement Loudspeaker System doesn't have any holes on the bottom for it to be mounted on a tripod/speaker stand.

Q: 6. Is this sold as a Pair of speakers or is it only 1 speaker?

A: It is sold as a single speaker.

Q: 7. Does this come in a 1 speaker option?

A: No, these speakers are offered in pairs only.

Q: 8. Is this active or passive?

A: This is a passive speaker, and requires a powered signal from an amplifier.

Q: 9. Does this product come with a pendant mount kit?

A: The Bose Professional FreeSpace FS4CE In-Ceiling 4.5" 200W Passive Loudspeaker (Pair, White) comes with mounting hardware for in-ceiling installation, as this is an in-ceiling speaker, not a pendant speaker.

Q: 10. How does it function the sound in the room ?

A: The speaker is an economic flush-mount ceiling loudspeaker for for general purpose applications. This full range loudspeaker is suitable for both speech and music reproduction in shops, department stores, schools, offices, sports halls, hotels and restaurants

Kevin	09/08/2024
[16 Ohms] If you know Tannoy - you know how good these sound. Powering them with a Sonos AMP and they look and work great. 5

Angel	05/08/2024
[120 W @ 16 Ohms] Very good 5

Darbs31	21/07/2024
[120 W @ 16 Ohms] I have a 3-way crossover inside my drum monitor and blew the speakers that were in it so I needed to replace the low end and the mid range speakers and I am very happy I chose this midrange speaker for the replacement. It works and sounds great on stage for my drummer. I have not blown it out as I am pushing 750 watts to it at the peak and it works good. I am very happy with this speaker. 5

Adam	16/07/2024
[18.165 lb] I got these for my Home theater, I have 7.2 system and use these as my back high speakers. I wanted a clean look so I opted for ceiling mount speakers. I picked these because I’ve had a great experience with Tannoy speakers in the past, and they are directional. 5

William	26/05/2024
[120 W @ 16 Ohms] I purchased these speakers to replace the 12 inch woofers that were in two PA 121 cabinets originally sold by Mackie Industrial. These were manufactured by RCF in Italy and rebranded as Mackie. The original 12s had basically rotted away and were unusable. I emailed Eminence and they confirmed that this would be a good replacement choice. The build quality of these Eminence speakers is very impressive and professional. When it came to testing, I was very pleasantly surprised! Punchy lows, very clean mids. In my system I have the cabinets set up for bi-amping. The crossover point is set at 3000 HZ. I would describe the sound as very musical and accurate. I also own a pair of QSC K 10s. I did an A-B comparison and found that the Mackie speakers with the eminence 12s sounded very similar to the K 10s but a little cleaner and much, much louder. The efficiency and output level is almost unbelievable at this price point. (about 300w available to each 12 inch and about 50w to each horn) The first time I had an opportunity to use these speakers was at an outdoor 5K race as an announce system at the finish line. We were covering an area about the size of two football fields with several thousand people. The sound was great and the customer was very happy. It sounded like a much larger system. One additional benefit, the cabinets are now noticeably lighter than they were before. That's always a plus! I highly recommend the speaker; you will not be disappointed. 5

Orlas92	13/05/2024
[120 W @ 16 Ohms] Very high quality for this price! 5

Paul	02/05/2024
[16 Ohms] This speaker has lots of punch. I use it with crown amplifiers, and you can really feel it in your chest. You'll need to purchase the box to mount the speaker separately. 5