[6.3 x 5 x 2.6"] I'm using these with my Ronin-S. I attach them with a small cheese plate to the back of the Ronin-S' camera plate and it allows me to offset or move forward my Sony X70 far enough to operate in underslung and flashlight mode clearing the rear motor assembly.
Props to Josh at Make Art Now for the tip.

[11.33 lb] Two years ago I made my worse mistake in quite some time - rather than weigh my SONY HDR-FX7 I estimated its weight, over-guessing by 30% (the camera weighs in under 5 pounds). And in doing so I bought the Glidecam 4000 Pro stabilizer, and have never been able to use it with that camera. But now with my purchase of the Camera Weight Plate by Glidecam, I can now use the stabilizer with both my FX7 and my heavier cameras. This simple little device not only saved me lots of money I would have spent on an additional stabilizer, but I can transport one stabilizer for my cameras rather than two or more.

[11.33 lb] Two years ago I made my worse mistake in quite some time - rather than weigh my SONY HDR-FX7 I estimated its weight, over-guessing by 30% (the camera weighs in under 5 pounds). And in doing so I bought the Glidecam 4000 Pro stabilizer, and have never been able to use it with that camera. But now with my purchase of the Camera Weight Plate by Glidecam, I can now use the stabilizer with both my FX7 and my heavier cameras. This simple little device not only saved me lots of money I would have spent on an additional stabilizer, but I can transport one stabilizer for my cameras rather than two or more.

[6.3 x 5 x 2.6"] For how inexpensive this is, you should absolutely have one available. At some point you will need to add weight on top for a smaller camera or other weight balance issues. Get it.

[11.33 lb] This is what was described and delivered quickly. It filled my needs

[11.33 lb] I bought 2 should of got 4. The weights are 1/8 thick, and pretty good weight to them. I have a glidecam HD2000 and small Sony NEX 5R. I ended adding 6 more weights from the glidecam to the top to make it heavier top. Then I put these 2 plates on top so it still looks nice. Highly recommend to anyone needing extra top weight. One thing I wish it had more holes but no issue, I have a drill and 1/4 Drill bit.

[11.33 lb] I found it as expected. Serves the purpose perfectly.

[6.3 x 5 x 2.6"] used this on the end of a selphy stick to help stabilize an LG 360 cam. I use 4 and my videos have smoothed out significantly.

[6.3 x 5 x 2.6"] Attached right into the cheese board I had on the underside of my camera rig. I was able to add the extra weight to it balance out for my flycam support vest.

[6.3 x 5 x 2.6"] So full disclosure I bought this for a DIY project. I'm using it as the base plate on my video dolly. The weight is nice to lower the center of gravity of the dolly. Tolerances on the holes seem pretty nice. As I'm only using it for 1 purpose I can't comment on the layout. I have noticed that after about a week of screwing and unscrewing the dolly the paint comes off quite easily. I don't care at all, but much some of you might. This has worked out pretty well for my specific purposes!